Industrial pulley 160 mm, 5 grooves, section C

EMMAR POLEA 160 5C is a reference of pulleys, within Power transmission. Request a quote for POLEA 160 5C via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The 160 5C pulley is a V-belt drive pulley, section C, with 160 mm diameter and 5 grooves. It is used to drive shafts from a motor or to distribute power between several shafts from a single belt. It is in-house manufacturing, EMMAR brand, so it is produced with direct control over groove machining and balancing. If you need to replace a worn pulley or build a new drive, this size covers medium and high power ranges.

This item is a pulley with 160 mm diameter, 5 grooves and section C. The designation POLEA 160 5C summarizes those three data points: the 160 mm outside diameter, the 5 grooves where the belts seat, and section C, which defines the width and depth of the groove. Section C is used with V-belts of profile C, the highest capacity within the classic sections. Being in-house manufacturing, EMMAR brand, groove machining and body balance are controlled in our plant.

Typical applications are power transmissions in industrial plants: fans, centrifugal pumps, screw compressors, conveyor belts and mixers. It is also used in agricultural machinery and in process equipment where speed needs to be increased or reduced with a fixed ratio. The 5 grooves allow the load to be distributed among several belts, which gives margin to transmit more power or to keep operating if one belt breaks, something valued in critical equipment that cannot stop without warning.

To mount this pulley, take into account the shaft diameter and the type of fixing: keyway, taper bushing or set screw, depending on how the bore is machined. Verify that the driving and driven pulleys are aligned in the same plane; a misalignment of a few degrees wears the belt and the groove. Belt tension is adjusted according to the equipment manual or with a tension gauge. If the pulley will rotate at high speeds, it is advisable to check balancing before putting it into service.

If you need an equivalent pulley or to change the number of grooves, send us the part number MR-POLEA-C5-160 or the designation POLEA 160 5C by WhatsApp. You can also send us the diameter, section and grooves you are looking for, and we will propose the corresponding in-house manufactured pulley or make it to measure. For replacements, if you have the old pulley at hand, send us a photo of the groove and the bore and we will help you identify the size.

At MR Accesorios Industriales we manufacture pulleys, split plummer block housings and ANSI chains, and we also sell bearings, power transmission, seals, bushings, mounting tools and lubricants. We know the equipment used in Argentine industry and can advise you on the pulley that best suits your drive. Write to us by WhatsApp with the item part number and we will quote you.