SE Split Plummer Block Housing

The SE split plummer block housing is a mounting component for bearings with a cylindrical bore that is split into two halves. This construction allows mounting or replacing it without disassembling the shaft or the transmission, which is key in equipment where access is limited and downtime must be minimized. To select it, consider the shaft diameter, the type of bearing it will accommodate and the load and speed conditions of the equipment.

The SKF SE series is identified by its split design and is complemented with sealing covers. In the code SE 509 K7, for example, the designation SE indicates the housing series, while the following numbers and letters define the size and mounting variants. It is commonly combined with bearings from the 222, 223 or 230 series, among others, depending on the application.

These housings are used in conveyors, mills, pumps, fans and power transmission equipment in general. Their ability to be mounted without disassembling the assembly makes them ideal for corrective and preventive maintenance in plants where every minute of downtime matters.

To request a quote for an SE split plummer block housing, send us the complete part number (for example, SE 509 K7), the shaft diameter and, if possible, the equivalent code you are using. With this information we confirm the exact reference and check availability.

At MR Accesorios Industriales we offer the SKF line of SE split plummer block housings with 18 references listed. If you need technical advice to select the right housing, contact us via WhatsApp or email and we will help you find the solution for your equipment.