Industrial pulley 600 mm, 3 grooves, section C

EMMAR POLEA 600 3C is a reference of pulleys, within Power transmission. Request a quote for POLEA 600 3C via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The 600 3C pulley is a V-belt drive pulley, section C, with a 600 mm diameter and three grooves. It is used to drive large shafts in milling, mixing, ventilation and conveying equipment, where the power needs to be distributed among several belts. It is in-house manufacturing, EMMAR brand, so it is machined to the dimensions and bore required by each application. If you need to replace a worn pulley or build a new drive, send us the part number and we will quote it.

This item is a pulley with a 600 mm diameter, 3 grooves and section C. The designation POLEA 600 3C summarizes those three variables: the 600 mm outside diameter, the number of grooves (3) and the belt section it accommodates, C. The grooves are turned so that the V-belt seats at the correct angle and transmits without slipping. It is a large-diameter pulley, designed for drive ratios where the driven shaft turns slower than the motor.

Typical applications of a 600 mm pulley with three section C grooves appear in equipment that moves a lot of inertia: mills, mixers, screens, high-flow centrifugal fans, conveyor belts and process pumps. In those cases, the three grooves allow the load to be distributed among several belts, which lowers the tension per belt and extends the life of the assembly. It is also used to replace sheet metal or cast iron pulleys that became oval or wore in the grooves.

To select this pulley properly, take into account the pitch diameter, the number of grooves, the belt section and the shaft diameter where it is mounted. Check that the driving and driven pulleys have the same section and number of grooves, and that the center distance allows the necessary wrap angle. The bore, keyway and set screws are defined according to the shaft. If the pulley works with a lot of vibration, it is advisable to balance it and check alignment with a straightedge or laser before tensioning.

If you need an equivalent pulley, send us the full part number, the diameter, the number of grooves and the belt section you use. It also helps if you tell us the shaft diameter and the type of mounting. With that data we look for the pulley that best fits within our in-house manufacturing line or we quote a custom one. It does not have to be exactly the same part number: we can compare alternatives.

To close the inquiry, send the part number POLEA 600 3C by WhatsApp to MR Accesorios Industriales along with the shaft size and the belt section. We will reply with the quote. If you have questions about mounting or balancing, we can also resolve them through that channel.