Flange bearing 3 holes LINK-BELT P3S2E36E

LINK-BELT P3S2E36E is a flange bearing 3 holes reference, within Bearing housings. Request a quote for P3S2E36E via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The 3-bolt flange bracket with insert bearing is a mounted assembly that combines a cast iron housing with a self-aligning insert bearing. It is used to support rotating shafts on structures where no flat base is available, such as machine sides, chassis or frames. The flange is fastened with three bolts and the insert locks onto the shaft, which simplifies assembly and replacement. MR Accesorios Industriales supplies this LINK-BELT line in Buenos Aires, Argentina.

The designation of this series is read in blocks: the initial P indicates a flange bracket, the first number after the P defines the housing size, the S indicates the insert type, and the following numbers correspond to the nominal shaft diameter and sealing variants. For example, P3S2E20E and P3S2E26E share the same housing and change the shaft diameter; P3S2E32E and P3S2E36E follow the same logic. That structure lets you request the complete code without ambiguity.

These brackets appear in material handling, conveyor belts, bucket elevators, mixers and process equipment. In Argentina they are seen in food, cement, quarry and agro-industrial plants, where the environment has dust, humidity or frequent washdowns. The three-bolt flange solves the support when the shaft runs parallel to a wall or a structural panel, and the self-aligning insert absorbs small misalignments from assembly.

To choose correctly, look at the shaft diameter, the insert's shaft locking type and the sealing: environments with fine dust or liquids require higher-protection seals. During installation, rest the flange on a clean, flat surface, tighten the three bolts in a cross pattern and check that the shaft turns without effort. The insert is lubricated through the built-in grease fitting; it is best to do it with the equipment stopped and without excess grease.

Flange brackets with insert bearing are interchangeable between manufacturers when the shaft diameter, the hole spacing and the locking type match. LINK-BELT is an official brand that MR supplies, and many references from other brands follow the same mounting standard. If the code you are looking for does not appear, send us the shaft and flange measurements: we will indicate the compatible alternative or manufacture it to measure.

To request a quote, write to us via WhatsApp with the complete code, for example P3S2E20E, or with the shaft and flange measurements. At MR Accesorios Industriales we reply promptly with the reference you need. We can also advise you on sealing and lubrication according to your plant's environment.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.