LINK-BELT P3S2E26E flange bearing 3 holes

LINK-BELT P3S2E26E is a reference of flange bearing 3 holes, within Bearing housings. Request a quote for P3S2E26E via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The 3-bolt flange bracket with insert bearing is a mounted unit that combines a cast iron housing with a self-aligning insert bearing. It is used to support rotating shafts on structures where no flat base is available, such as machine sides, chassis or frames. The flange is fastened with three bolts and the insert locks onto the shaft, which simplifies assembly and replacement. MR Accesorios Industriales sells this LINK-BELT line in Buenos Aires, Argentina.

The designation of this series is read in blocks: the initial P indicates a flange bracket, the first number after the P defines the housing size, the S indicates the insert type, and the following numbers correspond to the nominal shaft diameter and sealing variants. This structure allows the complete part number to be ordered without ambiguity.

These brackets appear in material handling, conveyor belts, bucket elevators, mixers and process equipment. In Argentina they are seen in food plants, cement plants, quarries and agro-industrial facilities, where the environment has dust, humidity or frequent washdowns. The 3-bolt flange solves the support when the shaft runs parallel to a wall or structural panel, and the self-aligning insert absorbs small misalignments from assembly.

To choose correctly, look at the shaft diameter, the type of insert-to-shaft locking and the sealing: environments with fine dust or liquids require seals with greater protection. During assembly, rest the flange on a clean, flat surface, tighten the three bolts in a cross pattern and check that the shaft turns without effort. The insert is lubricated through the built-in grease fitting; it is best to do this with the equipment stopped and without excess grease.

Flange brackets with insert bearing are interchangeable between manufacturers when the shaft diameter, hole spacing and locking type match. LINK-BELT is a brand MR sells, and many references from other brands follow the same mounting standard. If the part number you are looking for does not appear, send us the shaft and flange dimensions: we will indicate the compatible alternative or quote it to measure.

To request a quote, write to us on WhatsApp with the complete part number, or with the shaft and flange dimensions. At MR Accesorios Industriales we reply promptly with the reference you need. We can also advise you on sealing and lubrication according to your plant's environment.