DODGE INS-SC-104S insert bearing

DODGE INS-SC-104S is a reference of insert bearing, within Bearings. Request a quote for INS-SC-104S via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The DODGE SC series insert bearing is a ball bearing with an extended inner ring and set screw locking system, designed to be mounted in split plummer block housings and wall units. It is used in equipment where the bearing must be secured to the shaft and housed in a split housing to simplify mounting and maintenance. MR Accesorios Industriales carries this line as a brand.

The SC series designation is read from the complete part number: INS-SC-104S. The letters SC identify the insert bearing series with extended inner ring and set screw locking. The number that follows —104 in this case— indicates the nominal bore size according to the series table. The suffix S distinguishes the sealing variant. To order the correct replacement, provide the complete part number exactly as it appears on the nameplate or on the old bearing.

These inserts are mounted in split plummer block housings, wall, flange and take-up units, and appear in belt conveyors, bucket elevators, mixers, mills, centrifugal pumps and process equipment. In Argentina they are found in food plants, cement plants, tanneries, aggregate processing plants and packaging lines, where maintenance access is limited and it is preferable to replace the insert without disassembling the entire housing.

To select the insert, verify the shaft diameter and the locking type: SC inserts use set screws on the extended inner ring. Check the condition of the sealing, because in environments with dust, water or pressure washing a variant with an additional seal is preferable. During mounting, clean the shaft, verify there are no burrs or wear and tighten the set screws with a torque wrench to the recommended torque. Factory lubrication usually lasts for the service life, but in continuous service relubrication according to the duty cycle is advisable.

SC series insert bearings are interchanged between brands by bore number and locking configuration, not by the manufacturer's part number. If the housing is from another brand, what matters is the shaft diameter, the inner ring width and the position of the set screws. MR Accesorios Industriales will indicate the alternative compatible with the part number you provide. If the insert is mounted in a complete unit, it is advisable to also identify the housing to request a quote for the assembly.

If you need the DODGE SC series insert bearing, send us the part number INS-SC-104S or the shaft size and housing type via WhatsApp. At MR Accesorios Industriales we will quote it promptly and, if you are looking for another variant of the series, we will indicate the option that best suits your equipment.