DBH 5465 radial shaft seal — 93.64 x 130.15 x 12.7

DBH 5465 is a reference of radial shaft seal, within Seals. Request a quote for 5465 via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The DBH 5465 radial shaft seal is a lip seal mounted between a rotating shaft and its housing to retain lubricant and block the entry of dust, water or particles. Due to its dimensions and Lz design, it is used in gearboxes, pumps, electric motors and power transmission equipment where a shaft of approximately 94 mm diameter must be sealed. MR Accesorios Industriales carries this brand and helps you confirm the size before requesting a quote.

The DBH 5465 is a radial shaft seal with the following dimensions: shaft diameter 93.64 mm, housing diameter 130.15 mm and height 12.70 mm. The indicated design is Lz, which corresponds to a single lip configuration with spring, intended for rotating shafts with permanent lubrication. These dimensions are what you need to cross-check against the housing and shaft before ordering, because a seal that does not fit the diameter or height will not seal even if it belongs to the same family.

Typical applications for a seal of this size appear in equipment with medium-section shafts: gearboxes, reducers, centrifugal pumps, electric motors and transmission rollers. In all these cases the seal performs two functions at the same time: it retains the oil or grease on the inner side and blocks the entry of contaminants from the outside. When the seal wears out, the usual sign is a lubricant leak around the shaft area or the appearance of dirt inside the mechanism.

To choose the right replacement, in addition to the three dimensions, take into account the condition of the shaft surface: a scratched or worn shaft will wear out the new lip in a few hours. Also check that the housing has no burrs or deformations and lubricate the lip before mounting it. The Lz design defines the lip type and its spring, so if the original seal has another configuration, it is advisable to compare both product pages before replacing.

To quote part number 5465, the fastest way is to send us the dimensions of the old seal: shaft diameter, housing diameter and height. With those three data points, plus a photo of the part and the housing, we can look for the equivalent in the same brand or in another line we carry. It also helps if you tell us which equipment it works in, because that guides the lip type and material.

MR Accesorios Industriales carries the DBH brand. If you already have the DBH 5465 part number or the dimensions at hand, send them by WhatsApp and we'll send you the quote. If you are unsure between two sizes, write to us anyway: we'll help you confirm which one corresponds to your equipment before you place the order.