SKF UCPA 206 y-bearing unit

SKF UCPA 206 is a reference of y-bearing unit, within Bearing housings. Request a quote for UCPA 206 via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The UCPA bearing housing with SKF insert bearing is an assembly made up of a flanged cast iron housing and an insert bearing with an extended inner ring. It is used to mount rotating shafts on walls or flat structures, with fixed alignment and permanent lubrication. It is a compact, easy-to-mount solution for equipment where a shaft needs to be supported and allowed to rotate with low maintenance.

The UCPA designation is read in parts: UCP indicates it is a bearing housing with insert bearing, and the final A indicates the flange variant with mounting holes. The number that follows, as in UCPA 204 or UCPA 210, identifies the size of the insert bearing and the housing. The higher the number, the larger the permissible shaft diameter within the series. The examples in the series run from 204 to 210, and each part number should be ordered in full to avoid confusion.

These housings are used in conveyors, belts, mixers, fans, pumps and agricultural or food machinery. In Argentina they are common in food plants, cold storage facilities, mills and metalworking shops, where wall mounting simplifies the structure. They also appear in water treatment equipment and packaging lines, because they allow shafts to be supported with few anchoring points and tolerate small misalignments.

To choose the housing, take into account the shaft diameter, the type of load and the environmental conditions. The insert's sealing defines whether it withstands dust, water or frequent washdowns. Lubrication can be permanent or relubricable depending on the insert. During mounting, verify that the support surface is flat and that the mounting bolts are properly tightened. Aligning the shaft with the housing prevents stress and extends bearing life.

SKF UCPA housings are interchangeable with those of other brands that use the same nomenclature and standardized dimensions. When requesting a quote, it is advisable to indicate the full part number and, if possible, the shaft and housing dimensions. MR Accesorios Industriales carries this line and can guide you if you need to replace an existing assembly with one of similar characteristics.

If you already have the housing or insert bearing part number, send it by WhatsApp to MR Accesorios Industriales and we'll send you a quote. You can also ask about sealing variants within the same series.