Y-bearing unit SKF TUJ 60 TF

SKF TUJ 60 TF is a y-bearing unit reference, within Bearing housings. Request a quote for TUJ 60 TF via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The SKF Y-bearing unit TUJ TF series is an assembly consisting of a cast iron housing and an insert bearing with set screw locking. It is used to support rotating shafts in equipment where simple, robust mounting is required, with initial alignment and the ability to withstand combined loads. It is a common solution in machines operating in environments with dust or moderate humidity.

The designation TUJ corresponds to a cast iron Y-bearing unit with two mounting holes and an insert bearing. The number that follows indicates the shaft diameter for which it is intended, and the suffix TF identifies the type of seal and the tolerances of the insert. Thus, for example, TUJ 25 TF mounts on a 25 mm shaft, while TUJ 60 TF mounts on a 60 mm one. The series covers intermediate sizes such as TUJ 30 TF, TUJ 40 TF, TUJ 45 TF, TUJ 50 TF and TUJ 55 TF, always with the same locking configuration.

These units are used in belt conveyors, bucket elevators, mixers, mills, centrifugal pumps and industrial fans. In Argentina they are common in food plants, cement plants, tanneries and agricultural facilities, where dust and humidity require effective sealing. They also appear in road machinery and material handling equipment, thanks to their ability to absorb slight misalignments and moderate radial and axial loads.

To choose the correct unit, verify the shaft diameter and the type of load. The TF seal protects against contaminants and retains lubricant, so it is advisable in dirty environments. Mounting requires that the support surface be clean and flat; the set screws must be tightened with the appropriate wrench and to the recommended torque. It is important to align the unit with the shaft and lubricate the insert before starting up. Check axial and radial clearance after the first hours of operation.

Y-bearing units with insert bearing are interchangeable between brands in terms of main dimensions, but the locking system, sealing and load capacity may vary. When replacing a unit, compare the complete part number and the critical dimensions. The SKF TUJ TF series is an official brand that MR carries, which guarantees access to genuine products and technical advice to select the right variant.

If you need a Y-bearing unit for your equipment, send the exact part number via WhatsApp to MR Accesorios Industriales. With more than 80 years in the industry, we advise you so you choose the right size and seal. Request a quote with no obligation and receive personalized attention.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.