Y-bearing unit SKF SYKC 508 N

SKF SYKC 508 N is a y-bearing unit reference, within Bearing housings. Request a quote for SYKC 508 N via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The SKF SYKC N housing is an assembly consisting of a cast iron housing and an insert bearing with set screw locking. It is used to support rotating shafts in equipment where simple mounting and quick initial alignment are required. It is a common solution in low and medium demand machines, and MR Accesorios Industriales supplies it as part of its bearing housing line.

The designation SYKC N reads as follows: SYKC identifies the series of housings with insert bearing and set screw locking, and N indicates that the housing has a specific design within that category. Examples SYKC 506 N, SYKC 507 N and SYKC 508 N show the pattern: the three-digit number encodes the shaft diameter and the insert size. The higher the number, the larger the accepted diameter and the load capacity of the assembly. To choose the correct code, always start from the shaft diameter and then verify the locking type.

These housings appear in a wide variety of industries in Argentina. They are found in belt conveyors, mixers, fans, centrifugal pumps, mills and process equipment. They are also common in the food sector, where frequent cleaning requires easily disassembled components, and in aggregate or cement plants, where the environment is dusty. In all cases, the housing with insert allows replacing the bearing without completely disassembling the shaft, which simplifies maintenance.

To select the appropriate housing, consider the shaft diameter, the expected radial and axial load, and the environmental conditions. The insert seal is key: in dusty or humid environments, additional protection is advisable. Lubrication comes from the factory, but in service it should be checked periodically. During mounting, make sure the support surface is clean and flat, and tighten the set screws with the appropriate wrench to avoid deforming the inner ring. Careful alignment extends the service life of the assembly.

Regarding equivalences, housings with insert bearings are available from different brands under their own nomenclatures. The SKF SYKC N series can be interchanged with products from other manufacturers that share the same critical dimensions: shaft diameter, distance between mounting holes and height to center. It is not enough for the code to be similar; the dimensions must be compared. If you need to replace an existing housing, the safest approach is to send us the code stamped on the part or the main dimensions.

MR Accesorios Industriales supplies SKF SYKC N housings and can advise you to find the appropriate replacement. If you already have the code of the housing you use, send it via WhatsApp and we will quote it. If you do not have it at hand, send us a photo or the shaft and mounting hole dimensions, and we will help you identify it.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.