Solid-base split plummer block housing SKF SSED 513-611/MS1

SKF SSED 513-611/MS1 is a solid-base split plummer block housing reference, within Bearing housings. Request a quote for SSED 513-611/MS1 via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The SKF SSED split housing is a solid-base component that houses and secures bearings in rotating equipment. Its two-half design allows the bearing to be mounted and dismounted without dismantling the shaft or the transmission, which simplifies maintenance in the plant. It is used in conveyors, pumps, fans and general machinery, where robust and aligned retention is needed. MR Accesorios Industriales supplies this line with technical advice to choose the correct size.

The SSED designation identifies the category of solid-base split housings. The number that follows, as in SSED 513-611/MS1, indicates the combination of shaft diameter and mounting dimensions: the first figure is associated with the nominal diameter and the second with the center distance between the fastening holes. The MS1 suffix defines sealing variants or base configuration. To read a code correctly, it is advisable to check it against the manufacturer's table and verify the actual dimensions of the equipment.

These housings are used in the food, cement, paper and aggregate processing industries, among others. In Argentina they are commonly found in belt conveyors, bucket elevators, mixers and centrifugal pumps. Their solid base provides rigidity against loads and vibrations, and the split design makes bearing replacement easier in hard-to-reach places. They are also used in continuous process equipment, where every minute of downtime impacts production.

To select the housing, take into account the shaft diameter, the radial and axial load, and the environmental conditions. The sealing should be chosen according to the presence of dust, water or chemical agents; in humid environments additional protection is advisable. Mounting requires aligning both halves and tightening the bolts in a crosswise and progressive manner. Lubrication of the housed bearing must follow the manufacturer's recommendation, and internal clearance is checked after final tightening.

Split housings from different brands can be interchanged if the mounting dimensions, shaft diameter and housed bearing type match. However, it is not enough for the code to be similar: drawings and tolerances must be compared. There are equivalents on the market with different sealing systems and housing materials. MR Accesorios Industriales can guide you on available alternatives, always starting from the original part number and the dimensions measured on the equipment.

If you need to replace a split housing, send us the complete part number via WhatsApp. With that data and a photo of the assembly we can identify the part and offer you a compatible solution. We work with in-house manufacturing of housings, chains and pulleys. Write to us and we will reply with the quote.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.