SKF PER.CP213-HT y-bearing (insert bearing)

SKF PER.CP213-HT is a reference of y-bearing (insert bearing), within Bearings. Request a quote for PER.CP213-HT via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The SKF PER.CP-HT Y-bearing is an insert with set screw locking, designed to be mounted in split or pillow block housings. Its designation combines the PER series with the CP suffix, which indicates this type of locking, and HT, which indicates a heat treatment for high temperatures. It is used in equipment where the operating temperature exceeds that of a standard bearing, such as ovens, dryers or continuous process lines.

The PER.CP-HT designation reads as follows: PER identifies the series of inserts with metric dimensions; CP indicates locking by set screws on the inner ring; HT indicates that the bearing received a special heat treatment to withstand high temperatures. Examples in the series are PER.CP211-HT and PER.CP213-HT, where the numbers 211 and 213 correspond to insert sizes.

These bearings are used in industries such as food processing, ceramics, metallurgy and aggregate processing, where equipment operates with heat. They also appear in conveyors, bucket elevators, mixers and industrial fans. In Argentina, they are commonly found in grain drying plants, foundries and production lines that cannot stop due to premature failures. Their ability to withstand high temperatures makes them suitable for demanding environments.

To select the correct insert, take into account the shaft diameter, the type of load and the actual operating temperature. Mounting must be done on a shaft with adequate tolerance and a clean surface; the set screws are tightened with the corresponding wrench. Lubrication must be compatible with the operating temperature, and the housing seal prevents the entry of contaminants. Check the alignment between housings to avoid unforeseen axial loads.

Y-bearings with screw locking are interchangeable between brands as long as the main dimensions and the type of locking match. However, the HT suffix is not universal: other brands may identify it differently. Therefore, when looking for a replacement, do not rely only on the number; also compare the heat treatment and the service conditions. MR Accesorios Industriales can advise you if you have doubts.

If you need a quote for an insert from the series, send us the complete part number on WhatsApp. At MR Accesorios Industriales we will reply shortly with compatible alternatives. We give you a technical solution tailored to your equipment.