PEER UCP211-34 pillow block bearing

PEER UCP211-34 is a reference of pillow block bearing, within Bearing housings. Request a quote for UCP211-34 via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The UCP housing with PEER insert bearing is a pillow block mounted unit that combines an insert ball bearing with a cast iron housing. It is used to support rotating shafts in equipment where simple fixing and adequate alignment are required. MR Accesorios Industriales sells this line for industrial applications in Buenos Aires, Argentina.

The UCP designation identifies the series of pillow block housings with insert bearing. The number that follows indicates the size: for example, UCP201-8, UCP202-9, UCP203-11, UCP204-12, UCP205-13 and UCP205-14. In these codes, the first two digits of the number (20, 21, etc.) relate to the insert bearing series, while the suffix after the hyphen indicates the shaft diameter in inches. Thus, UCP201-8 corresponds to a 1/2" shaft, UCP202-9 to 9/16", UCP203-11 to 11/16", UCP204-12 to 3/4", UCP205-13 to 13/16" and UCP205-14 to 7/8". Understanding this logic allows you to interpret the code and select the correct unit.

These housings are used in a wide variety of industries in Argentina: from conveyor lines and grain elevators to machines for the food, textile, wood and packaging industries. They also appear in irrigation equipment, fans, mixers and conveyor belts. Their pillow block design facilitates mounting on metal or concrete structures, and the insert bearing tolerates slight misalignments, which simplifies installation on shafts that are not perfectly aligned.

To correctly select a UCP housing, take into account the shaft diameter, the type of load (radial, axial or combined) and the environmental conditions. The insert bearing usually comes pre-lubricated and with seals that retain grease and block the ingress of dust and moisture. During mounting, verify that the support surface is clean and flat, and that the fixing screws are tightened according to the recommended torque. Initial shaft alignment avoids unnecessary stresses and prolongs the service life of the assembly. If the environment is very humid or has particles, consider additional protections.

Regarding equivalences, UCP housings from different brands often share standardized dimensions, which allows them to be interchanged in many applications. If you need to replace an existing unit, the most practical approach is to identify the complete code engraved on the housing or measure the shaft diameter and the distance between fixing holes. With that data, at MR Accesorios Industriales we will quote the equivalent reference or the one that best suits your equipment. Interchangeability between brands is common in this product family, as long as the main dimensions are respected.

If you are looking for a UCP housing with PEER insert bearing, write to us via WhatsApp with the code or your shaft measurements. At MR Accesorios Industriales we will quote the exact reference and advise you so that the unit works correctly in your application. We handle inquiries from all over the country and ship to Buenos Aires and the interior.