PEER UCHA207-35mm hanger bearing

PEER UCHA207-35mm is a reference of hanger bearing, within Bearing housings. Request a quote for UCHA207-35mm via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The UCHA hanger bearing unit with PEER insert bearing is a mounted assembly that fastens to a structure to support rotating shafts in power transmission applications. It consists of a fork-shaped cast iron housing and an insert ball bearing with an extended inner ring, which allows direct mounting on the shaft. It is used in conveyors, elevators and process lines where an intermediate or end support with flexible alignment is required.

The UCHA designation identifies the series of hanger bearing units with insert bearing. The numbers that follow indicate the size: UCHA201-12mm corresponds to a 12 mm shaft, UCHA202-15mm to 15 mm, UCHA203-17mm to 17 mm, UCHA204-20mm to 20 mm, UCHA205-25mm to 25 mm, UCHA206-30mm to 30 mm, UCHA207-35mm to 35 mm and UCHA208-40mm to 40 mm. The MM suffix confirms that the dimensions are in millimeters. This series covers a shaft range from 12 to 40 mm, in standardized increments.

These bearing units are used in belt and roller conveyors, bucket elevators, mixers, mills and process equipment in the food, chemical, cement and material handling industries. In Argentina, they are common in animal feed plants, aggregate processing plants and packaging lines. Their hanger design allows them to be mounted suspended from a beam or structure, leaving the shaft free below to transmit motion.

To select the bearing unit, check the shaft diameter and the load and speed conditions. The insert bearing has an inner ring that is fixed to the shaft by means of set screws; it is important to tighten them with the appropriate wrench and to verify that the shaft is clean and free of burrs. Factory lubrication is lithium grease based, but in humid or dusty environments it is advisable to check the sealing and relubricate according to the maintenance plan. Alignment between bearing units must be careful to avoid axial loads.

UCHA bearing units are interchangeable between different brands that manufacture insert bearings with the same basic dimensions. When replacing an assembly, compare the shaft diameter, the distance between the centers of the mounting holes and the overall height. If the original bearing unit has an equivalent designation, you can ask us and we will indicate the compatible alternative. Interchangeability simplifies maintenance and reduces downtime.

To request a quote for the UCHA bearing unit you need, write to us on WhatsApp with the full part number, for example UCHA205-25mm, or with the shaft size. At MR Accesorios Industriales we reply shortly with availability and commercial terms. We can also advise you if you have doubts about selection or mounting.