PEER GRHA212-39 hanger bearing

PEER GRHA212-39 is a reference of hanger bearing, within Bearing housings. Request a quote for GRHA212-39 via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The PEER GRHA hanger bearing unit is a mounted bearing with a pendular housing that is fastened to a structure by means of a top flange. It is used to support rotating shafts in conveyors, elevators and transmission lines, where alignment may vary. Its design allows mounting in any orientation and makes greasing and replacement of the insert easier.

The GRHA designation identifies the PEER hanger bearing unit series. The number that follows indicates the nominal shaft diameter and, when a hyphenated suffix appears, the inch measurement or the fastening variant. For example, GRHA204-12 and GRHA204-13 correspond to 3/4" and 13/16" shafts respectively, while GRHA205-13 to GRHA205-16 cover measurements from 13/16" to 1". To choose the correct code, have the shaft diameter and the mounting type on hand.

These units are used in belt and chain conveyors, bucket elevators, mixers, screens and process equipment in food, chemical and aggregate plants. In Argentina, they are common in the oilseed and milling industries and in waste treatment plants. Their oscillating capability compensates for slight misalignments and absorbs vibrations, which extends the service life of the insert bearing and reduces maintenance downtime.

To select the unit, check the shaft diameter, the expected radial and axial load, and the environmental conditions. In dusty or humid environments, choose inserts with reinforced sealing and keep up periodic greasing. During mounting, make sure the flange is firm and that the shaft does not transmit additional stresses. Lubrication should be renewed according to the duty cycle, and it is advisable to check clearance and alignment after the first hours of operation.

PEER GRHA hanger bearing units can be interchanged with other brands that use the same mounting nomenclature. Shaft measurements and flange diameters usually match between manufacturers, but always verify the critical dimensions before replacing. If the part does not have a legible code, we identify it by its dimensions and quote it for you.

To request a quote for the GRHA unit you need, send the complete code or the shaft dimensions on WhatsApp to MR Accesorios Industriales. We reply promptly with availability and compatible alternatives. We can also advise you if you have doubts about the designation or the mounting.