Industrial pulley 180 mm, 7 grooves, section B

EMMAR POLEA 180 7B is a reference of pulleys, within Power transmission. Request a quote for POLEA 180 7B via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The 180 7B pulley is a V-belt transmission pulley, section B, with a 180 mm diameter and 7 grooves. It is used to drive several shafts from a single motor, for example in blow molding lines, compressors, screens or process machines. As it is in-house manufactured, EMMAR brand, the machining and balancing can be adjusted according to the application. If you need to replace an existing pulley, send us the part number and the shaft dimensions.

This pulley has a 180 mm diameter, 7 grooves and section B. It is a cast iron pulley, machined for section B V-belts, with ground grooves so that the belt seats well and does not slip. The 180 mm diameter and the 7 grooves define the transmission ratio and the number of belts you can mount. It is manufactured at MR with dimensional control, and balancing is done according to the working speed you indicate to us.

It is used in transmissions where power must be distributed among several shafts or several belts must be kept in parallel so as not to overload a single one. It appears in screw compressors, blowers, screens, mills, mixers and transmission lines of process plants. It is also chosen when an original pulley must be replaced and the exact size cannot be found: since it is in-house manufacturing, the bore, the keyway and the outer diameter can be machined as needed.

To mount it, verify that the shaft is clean, free of burrs and with the key in good condition. The bore and the keyway are machined according to the shaft you indicate to us. Align the pulleys with a straightedge or laser: a misalignment of a few degrees wears out the belt and the bearings. Belt tension is adjusted according to the equipment manual; if you do not have it, it is adjusted until the belt does not slip on startup. If the pulley works at high speed, it should be balanced.

To request an equivalent, send us the full part number, the diameter, the number of grooves and the belt section. If you have the old pulley, send us the shaft diameter, the groove width and the type of key. With that data we will propose a pulley from the same series or a variant with another diameter or number of grooves. We can also manufacture a custom pulley if the space or the transmission ratio requires it.

If you need a quote for the 180 7B pulley or a similar one, send the part number via WhatsApp to MR Accesorios Industriales. We will reply with the data needed to confirm the machining. You can also ask about pulleys of other sections, grooves or diameters within the power transmission line.