Double sprocket with hub, pitch 5/8", 36 teeth

MR Piñón doble 5/8" Z36 is a sprockets and gears reference, within Power transmission. Request a quote for Piñón doble 5/8" Z36 via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

Its hub design allows it to be mounted on shafts and secured with set screws or a key, depending on the case. It is used in equipment where a simple and reliable reduction is needed, with good meshing and even wear. If you need a wheel for replacement or for a new machine, this sprocket is a concrete option to keep in mind.

This item is a double sprocket with hub, with 5/8" pitch and 36 teeth (z=36). It is made of SAE 1045 steel, a material commonly used in power transmission for its strength and machinability. The term double refers to the fact that it has two toothed crowns, which allows it to drive two chains in parallel or to duplicate the transmission on the same shaft. The hub is the central part that rests on the shaft and facilitates fastening. All these characteristics are confirmed in our product page and are maintained for every piece that leaves the factory.

Typical applications of a sprocket like this appear in chain conveyors, bucket elevators, agricultural machines and material handling equipment. It is also found in production lines where two chain strands need to be synchronized with a single wheel. Being made of SAE 1045 steel, it resists contact wear well and accepts surface treatments if the environment is demanding. It is a frequent replacement part in plants that work with 5/8" pitch chains and seek to maintain cadence without stopping the line.

To mount this sprocket, verify that the shaft diameter matches the hub bore and that the key or set screws are in good condition. Check the alignment between the sprocket and the driven wheel: misalignment accelerates wear on teeth and chain. Proper lubrication and correct chain tension also influence service life. If the sprocket runs at high speeds, it is advisable to check balancing. If in doubt, ask us and we will help you select the most suitable configuration for your equipment.

If you need a sprocket with a different number of teeth, another pitch or a different hub, we can manufacture it. To request an equivalent or a nearby size, send us the part number MR-PINON-DOBLE-5-8-Z36 or the full designation by WhatsApp. You can also send us a photo or a sketch with the main shaft and tooth dimensions. With that data, we review feasibility and send you a proposal.

If this model fits your need, write to us by WhatsApp with the part number and we will quote it. If not, tell us what size you are looking for and we will evaluate it.