LINK-BELT UG320L insert bearing

LINK-BELT UG320L is a reference of insert bearing, within Bearings. Request a quote for UG320L via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The LINK-BELT UG…L series insert bearing is a ball bearing with an extended inner ring, designed to be mounted in split housings and wall units. It is used in equipment where the shaft rotates and needs support with alignment and sealing. Its design allows the inner ring to be secured to the shaft and, in many cases, the axial position to be adjusted. MR Accesorios Industriales sells this line for plants, workshops and maintenance in Buenos Aires, Argentina.

The UG…L series designation is read in parts: the letters UG identify the family of inserts with an extended inner ring; the number that follows indicates the size within the 300 series; and the final letter L distinguishes the sealing or configuration variant of the insert. Not all sizes in the series share the same final letter, so it is best to verify the complete part number when ordering the replacement.

These inserts are mounted in split housings, flange units and take-up frames, and appear in conveyors, mixers, pumps, fans and process machinery. In Argentina they are found in food, cement, paper and agro-industrial plants, where maintenance demands parts that withstand dust, moisture and moderate loads. The 300 series covers a wide range of shaft diameters, which is why it is common in equipment that already has compatible housings.

To select the insert, start with the shaft diameter and the type of housing it will sit in. Check the sealing: a single lip is enough in clean environments, while in areas with dust or water a more closed protection is advisable. Factory lubrication is usually sufficient for start-up, but in continuous service grease must be replenished according to the duty cycle. During mounting, align the housing and tighten the inner ring set screws without forcing, so as not to deform the raceway.

As for equivalents, inserts are compared by shaft diameter, inner ring width and locking type. Different brands use their own nomenclatures, so interchangeability is confirmed by cross-checking those dimensions and the housing shape. The compatible alternative with the same geometry is sought. MR Accesorios Industriales can tell you that equivalent if you send the old part number or the shaft dimensions.

If you need to replace a LINK-BELT UG…L series insert, send the complete part number by WhatsApp to MR Accesorios Industriales. With that information we will quote the part and, if applicable, indicate the compatible alternative. You can also ask about other sizes in the 300 series or about split housings to complete the assembly.