Insert bearing LINK-BELT UBG2M20NL*■

LINK-BELT UBG2M20NL*■ is a insert bearing reference, within Bearings. Request a quote for UBG2M20NL*■ via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The LINK-BELT 200 series insert bearing is a ball bearing with an extended inner ring, designed to be mounted in split or pillow block housings to form a compact support unit. It is used in equipment where a rotating shaft needs to be supported with simple alignment and accessible maintenance, such as conveyors, fans, mixers and plant machinery. MR Accesorios Industriales sells this line as an official brand and advises you on choosing the correct variant according to the shaft and housing.

The 200 series designation is read in blocks: the initial letters identify the insert family and the three-digit number indicates the bore size, which in this series is expressed in sixteenths of an inch. For example, UBG2M17NL*■ corresponds to an insert for a 1.1/16" shaft, UBG2M20NL*■ for 1.1/4", UBG2M25NL*Δ■ for 1.9/16" and UBG2M50NL*Δ■ for 3.1/8". The suffixes that follow the size indicate sealing, locking or material variants, and they should be reviewed when ordering the replacement.

In Argentine industry, these inserts are found in belt and roller conveyors, bucket elevators, mixers, dryers, centrifugal fans and process equipment in food, chemical and aggregate plants. They also appear in agricultural machinery and packaging lines, where the split housing allows the shaft to be removed without disassembling the entire assembly. They are a practical solution when looking for an economical support, easy to replace and with good tolerance to moderate contamination.

To select the insert, start with the shaft diameter and the housing where it will be seated: the insert must match the outer diameter and the width of the housing. Check the sealing type according to the environment: labyrinth or contact seals for dust and moisture, and simple seals for clean service. During mounting, verify that the shaft is clean and free of burrs, place the insert without striking the outer ring and tighten the set screws or eccentric locking collar according to the design. Lubricate with the specified grease and check the housing alignment to avoid lateral loads.

The 200 series insert bearings are available from different brands with standardized dimensions, so interchangeability is usually resolved by comparing shaft diameter, outer diameter, width and locking type. The series number alone is not enough: the complete designation must be cross-referenced, including the sealing suffixes and the housing letters. If the original part number is not available, it can be replaced by an equivalent insert from another manufacturer as long as those dimensions and the locking system match.

If you need a LINK-BELT 200 series insert, send us the complete part number shown on the housing or on the equipment nameplate. At MR Accesorios Industriales we will quote it for you and, if necessary, indicate the compatible alternative with the same dimensions. Write to us on WhatsApp with the model and quantity: we will reply shortly.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.