LINK-BELT P3Y2E32N pillow block bearing

LINK-BELT P3Y2E32N is a reference of pillow block bearing, within Bearing housings. Request a quote for P3Y2E32N via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The LINK-BELT pillow block with insert bearing is an assembled foot-mounted unit that combines a cast iron housing with an insert bearing. It is used to support rotating shafts in equipment where the bearing must be aligned, fastened and protected in a single piece. It is common in conveyors, fans, mixers and process machinery, and simplifies assembly because it arrives ready to install on a bedplate.

The designation of these brackets is read in blocks. The initial letter P indicates a pillow block; the number that follows refers to the size and series of the insert. The Y indicates the housing configuration, the E the locking or seal type, and the N the finish or variant of the unit.

In Argentine industry these brackets appear in belt and chain conveyors, bucket elevators, mixers, exhausters, mills and packaging lines. They are chosen when the working shaft is relatively long and it is convenient to support it at several points with compact, self-aligning units. They are also used in food, chemical and cement plant equipment, where the environment may have dust, humidity or frequent washdowns.

To select correctly, take into account the shaft diameter, the load type and the force direction. The insert allows some initial misalignment, but the bedplate must be flat and the bolts properly tightened. Check the sealing: if there is fine dust or liquids, additional protection is recommended. Insert lubrication is permanent in most cases, although in severe environments it is advisable to check the condition of the seal and the working temperature.

Pillow blocks with insert bearing are interchangeable between brands if the main dimensions match: height to center, hole spacing, shaft diameter and locking type. LINK-BELT, Rexnord and other equivalent lines often share these dimensions, but always verify the complete part number before replacing. If the original bracket has a different sealing or locking variant, the housing may not match even if the bearing is the same.

To request a quote for the bracket you need, send us on WhatsApp the part number shown on the part or drawing. At MR Accesorios Industriales we will quote it and, if applicable, indicate the compatible alternative. We can also advise you on assembly and lubrication according to the type of equipment and the working environment.