Pillow block bearing LINK-BELT P3Y2E20N

LINK-BELT P3Y2E20N is a pillow block bearing reference, within Bearing housings. Request a quote for P3Y2E20N via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The Soporte Y with LINK-BELT insert bearing is a pre-assembled pillow block unit that combines a cast iron housing with a 200 series insert bearing. It is used to support rotating shafts in equipment where the bearing must be aligned, secured and protected in a single piece. It is common in conveyors, fans, mixers and process machinery, and simplifies assembly because it arrives ready to install on a baseplate.

The designation of these housings is read in blocks. The initial letter P indicates pillow block; the number that follows, as in P3Y2E20N, refers to the size and series of the insert, in this case the 200 series. The Y indicates the housing configuration, the E the type of fastening or seal, and the N the finish or variant of the assembly. The examples P3Y2E20N and P3Y2E32N show how the code changes according to shaft diameter: same housing, different insert.

In Argentine industry these housings appear in belt and chain conveyors, bucket elevators, mixers, exhausters, mills and packaging lines. They are chosen when the working shaft is relatively long and it is convenient to support it at several points with compact, self-aligning units. They are also used in food, chemical and cement plant equipment, where the environment may have dust, humidity or frequent washdowns.

To select correctly, take into account the shaft diameter, the type of load and the direction of the force. The 200 series insert tolerates a certain initial misalignment, but the baseplate must be flat and the bolts properly tightened. Check the sealing: if there is fine dust or liquids, additional protection is advisable. Insert lubrication is permanent in most cases, although in severe environments it is recommended to check the condition of the seal and the working temperature.

Pillow blocks with insert bearing are interchangeable between brands if the main dimensions match: height to center, distance between holes, shaft diameter and type of fastening. LINK-BELT, Rexnord and other equivalent lines usually share these dimensions, but always verify the complete code before replacing. If the original housing has a different sealing or fastening variant, the housing may not match even if the bearing is the same.

To request a quote for the housing you need, send us via WhatsApp the code that appears on the part or on the drawing, for example P3Y2E20N. At MR Accesorios Industriales we will quote it and, if applicable, indicate the compatible alternative. We can also advise you on assembly and lubrication according to the type of equipment and the working environment.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.