LINK-BELT FX3S2E20E flange bearing 2 holes

LINK-BELT FX3S2E20E is a reference of flange bearing 2 holes, within Bearing housings. Request a quote for FX3S2E20E via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

LINK-BELT flange bearing housings are mounted units with a built-in bearing, designed to secure rotating shafts to walls, chassis or structures. They are used when the shaft must sit perpendicular to the mounting surface and firm fastening with two anchor points is required. MR Accesorios Industriales sells this line for power transmission and conveying equipment in plants across Argentina.

The designation of these housings combines letters and numbers that identify the unit type, shaft diameter and sealing system. Examples FX3S2E20E, FX3S2E26E, FX3S2E32E and FX3S2E36E show how the part number changes with shaft size: the two digits before the final letter indicate the nominal diameter in inches. The letter S refers to the housing type and the final E to the sealing configuration. Understanding this logic lets you order the correct replacement without mistakes.

These housings are used in belt conveyors, bucket elevators, mixers, agitators and process equipment where the shaft runs horizontally or vertically with a mounting flange. In Argentina they are found in food, cement, grain and chemical plants, wherever a rugged unit that is easy to replace is required. The two-bolt flange simplifies mounting on steel structures or masonry, and the built-in bearing handles radial loads and some axial thrust.

To select the right housing, take into account the shaft diameter, the type of load and the environmental conditions. Sealing is key: in dusty or damp environments, check the seal type and whether labyrinths are present. Lubrication must be the one specified for the built-in bearing, and mounting requires aligning the flange with the shaft to avoid parasitic loads. Uneven fastening or over-tightening the bolts can distort the housing and shorten service life.

As for equivalents, flange housings are interchangeable across different brands that use the same basic nomenclature, although the housing material, seal type or bearing tolerance may vary. So when ordering a replacement, it is best to send the full part number and shaft dimensions. MR Accesorios Industriales will point you to the compatible alternative so your equipment keeps running.

If you have the housing part number or the shaft size, send it by WhatsApp to MR Accesorios Industriales and we will quote it shortly. We can also advise you on lubrication and mounting so the unit works under the best conditions.