LINK-BELT FX3CL232N flange bearing 2 holes
- Brand
- LINK-BELT
- Category
- Bearing housings
- Subcategory
- Bearing housings
- Series
- 200
We respond promptly.
Since 1945 · Martínez, Buenos Aires, Argentina
Request your quote via WhatsApp or email, with the quantity you need.
Can't find the exact model? Write to us with the part number or model you're looking for: we'll find it and quote it, even if it's not listed in the catalog.
Description
LINK-BELT FX3CL232N is a reference of flange bearing 2 holes, within Bearing housings. Request a quote for FX3CL232N via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.
The LINK-BELT 200 series 2-bolt flange bearing is a mounted bearing ready to be fastened with two bolts onto a flat surface. It is used to support shafts in equipment where the mounting must sit flush, with the flange against the structure. MR Accesorios Industriales sells this line and will quote the exact part number you need by WhatsApp.
The designation starts with FX followed by a number indicating the shaft diameter: FX3CL210N, FX3CL211N, FX3CL212N and so on. The letters CL identify the 2-bolt flange series. The final N indicates the locking type, and the symbols appearing in some part numbers distinguish sealing or housing variants. Send us the full part number and we will quote the exact reference.
These flange bearings are found in belt conveyors, bucket elevators, mixers, screens and process lines in food, chemical and aggregate plants. In Argentina they are common in material handling equipment and in machines working with horizontal shafts supported on steel structures. The two-bolt flange simplifies mounting when there is no room for a foot-mounted base.
To choose correctly, check the shaft diameter and the bolt hole spacing of the flange. Sealing is key: in dusty or humid environments, a variant with a reinforced seal is advisable. When mounting, seat the flange on a clean, flat surface, tighten the bolts in a cross pattern and check shaft alignment. Factory lubrication is enough for start-up; afterwards follow the equipment maintenance plan.
200 series flange bearings are interchanged between brands by shaft number and flange configuration. LINK-BELT, Rexnord and other lines use similar designations, but suffixes and seals change. If you have the old part number, send it: we will indicate the compatible alternative or quote it made to measure if needed.
MR Accesorios Industriales sells LINK-BELT. Send us by WhatsApp the part number shown on your equipment and we will quote it shortly.
Dimensions
Dimensions and tolerances: Send us the part number via WhatsApp and we'll confirm the dimensions and version against the manufacturer's data sheet.
Frequently Asked Questions
- How do I identify the flange bearing I need?
- Take the part number stamped on the bearing or measure the shaft diameter and the bolt hole spacing of the flange. With that data we will quote the corresponding LINK-BELT 200 series reference.
- What does the CL abbreviation mean in the designation?
- CL identifies the 2-bolt flange series within the LINK-BELT line. The number that follows indicates the shaft diameter, and the final N indicates the locking type.
- Can it be replaced by another brand?
- Yes, 200 series flange bearings are interchanged between brands by shaft number and configuration. Send us the original part number and we will indicate the compatible alternative.