LINK-BELT FC4CL2M55N flange bearing 4 holes

LINK-BELT FC4CL2M55N is a reference of flange bearing 4 holes, within Bearing housings. Request a quote for FC4CL2M55N via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The LINK-BELT series 200 4-bolt flange bearing is a mounted bearing ready to install on a flat face with four bolts. It is used to guide shafts in equipment where rigid fixing and simple alignment are required, without machining the housing. MR Accesorios Industriales supplies this line in Buenos Aires, Argentina, and quotes the exact part number you need by WhatsApp.

The designation of these bearings is read in blocks: the initial letters indicate the type of flange and mounting, the central number defines the series and size, and the suffixes indicate sealing, fixing or bearing configuration variants. For example, FC4CL2M55N combines the 4-bolt flange, the 200 series and a shaft diameter of 55 mm. If your part number does not exactly match that format, send us the complete model and we will indicate the compatible alternative.

They are used in conveyors, mixers, pumps, fans, belts and process equipment where the shaft requires support and continuous rotation. In Argentina they appear in food, chemical, cement, meatpacking and agricultural plants, both in new lines and in maintenance replacements. The 4-bolt flange allows mounting on sheet metal or cast iron with a flat surface and four bolts, which simplifies commissioning and replacement.

To choose correctly, take into account the shaft diameter, the type of load and the environmental conditions. The sealing determines whether the bearing withstands dust, water or frequent washdowns; lubrication must be the one indicated for the working speed and temperature. During installation, rest the flange on a clean, flat surface, tighten the bolts in a cross pattern and check shaft alignment before starting up. Poor alignment shortens bearing life.

Mounted bearings are interchanged between brands by series number, shaft diameter and flange configuration, but not all suffixes are equivalent. When replacing, compare the number of holes, the center distance, the type of sealing and the shaft fixing system. At MR Accesorios Industriales we indicate the compatible alternative or quote it to measure.

To proceed with your inquiry, send us by WhatsApp the complete part number of the bearing, the shaft diameter and a photo of the installation if you have one. With that data we will quote promptly and advise you on the variant that best suits your equipment. We handle technical inquiries from all over Argentina.