LINK-BELT F3CL2B16N flange bearing 4 holes
- Brand
- LINK-BELT
- Category
- Bearing housings
- Subcategory
- Bearing housings
- Series
- CL
We respond promptly.
Since 1945 · Martínez, Buenos Aires, Argentina
Request your quote via WhatsApp or email, with the quantity you need.
Can't find the exact model? Write to us with the part number or model you're looking for: we'll find it and quote it, even if it's not listed in the catalog.
Description
LINK-BELT F3CL2B16N is a reference of flange bearing 4 holes, within Bearing housings. Request a quote for F3CL2B16N via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.
The Link-Belt CL series 4-bolt flange bearing is a mounted bearing with a square flange housing and mounting holes, designed to support rotating shafts on flat structures. It is used when the shaft runs perpendicular to the mounting surface and firm fastening with good load capacity is required. MR Accesorios Industriales sells this line, with technical advice to choose the right size.
The CL series designation is read in blocks: the initial F indicates the 4-bolt flange housing, the number after CL corresponds to the nominal shaft diameter and the final letters identify the locking type and sealing. That is why codes in the series share the same housing and differ only in shaft size. Send the full code on WhatsApp and we will indicate the exact equivalent.
These bearings appear in belt and roller conveyors, packaging lines, mixers, blowers, bucket elevators and process lines in food, chemical and aggregate plants. In the Argentine market they are widely requested for replacement in equipment that already has a 4-bolt flange and needs a mounted unit ready to install, without machining the structure.
To select correctly, take into account the radial and axial load, the rotational speed and the environment: if there is dust or water, a tighter seal is advisable, and if the shaft expands due to temperature, a unit with adequate internal clearance. During mounting, rest the flange on a flat, clean surface, tighten the four bolts in a cross pattern and check shaft alignment before lubricating and starting up.
Flange mounted units are interchanged between manufacturers by number of holes, center distance, shaft diameter and locking type, but housing dimensions do not always match. Always compare the flange drawing and the shaft diameter before replacing one unit with another. If you send us the original part number, we will indicate the compatible alternative.
MR Accesorios Industriales manufactures split plummer block housings, ANSI chains and pulleys, in addition to selling bearings and power transmission accessories. Send us on WhatsApp the F3CL2B code shown on your equipment, with a photo of the flange if you can, and we will quote you promptly.
Dimensions
Dimensions and tolerances: Send us the part number via WhatsApp and we'll confirm the dimensions and version against the manufacturer's data sheet.
Frequently Asked Questions
- How do I identify the size of the Link-Belt CL series bearing I need?
- Take the code stamped on the housing or flange and send it complete on WhatsApp. The number after CL indicates the shaft diameter, and the final letters define locking and sealing. With that data we will quote you the correct unit.
- Can it be replaced by another brand of flange bearing?
- In many cases yes, if the number of holes, center distance, shaft diameter and locking type match. Housing dimensions vary between manufacturers, so it is advisable to compare the flange drawing before installing. Send us the original code and we will indicate the alternative.
- What should I check before mounting a flange bearing?
- Check that the mounting surface is flat and clean, that the four bolts tighten in a cross pattern and that the shaft is aligned with the equipment. Then lubricate according to the unit type and check clearance before starting up. If you have doubts, write to us on WhatsApp.