Pillow block bearing DODGE P2B-SCEZ-104S-SH

DODGE P2B-SCEZ-104S-SH is a pillow block bearing reference, within Bearing housings. Request a quote for P2B-SCEZ-104S-SH via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The SCEZ series Y-bearing pillow block is a mounted pillow block unit that combines a cast iron housing with an insert ball bearing, already aligned and ready to bolt to the structure. It is used to support rotating shafts in equipment where mounting must be simple and replacement quick, without machining housings or adjusting tolerances on site. MR Accesorios Industriales supplies this DODGE line in Buenos Aires, Argentina.

The SCEZ series designation is read in blocks: the letters identify the pillow block family and the insert type, and the numbers in the middle indicate the shaft size. In a code such as P2B-SCEZ-104S-SH, the prefix defines the housing configuration, the SCEZ segment corresponds to this series, and the final number indicates the nominal shaft size in inches. The SH suffix refers to the sealing and insert locking variant. With the complete code, the part you need is identified unambiguously.

These pillow blocks appear in belt conveyors, bucket elevators, mixers, screens, packaging lines and aggregate processing equipment. In Argentine industry they are widely seen in food plants, cement plants, feed lots and grain depots, where the environment has dust, humidity or frequent washdowns. The cast iron housing withstands the rough handling of mounting and the insert bearing absorbs minor shaft misalignment, which is key when the structure is not perfect and the equipment must keep running without vibration.

To choose well, first look at the shaft diameter and the insert locking type: there are units with set screws, with eccentric collar or with taper sleeve, and each is mounted differently. Then evaluate the sealing: in environments with water or fine dust, a labyrinth or heavier-duty seal is advisable. Insert lubrication is permanent in most cases, but in severe applications it is recommended to check the grease condition when disassembling. Base alignment is critical: rest the pillow block on a flat surface and tighten the bolts in a cross pattern.

Regarding equivalents, Y-bearing pillow blocks are interchanged between brands by shaft size and housing configuration, not by code. A two-bolt pillow block with a one-inch insert can replace another of the same size even if the manufacturer prefix changes. What must be compared is the shaft diameter, the base hole spacing, the height to center and the locking type. If in doubt, send us the dimensions or a photo of the old part and we will indicate the compatible alternative.

If you already have the code of the pillow block you are replacing, write to us on WhatsApp and we will quote you promptly. We can also verify interchangeability with other brands and, if the equipment allows, offer you an alternative of the same size. MR Accesorios Industriales works with DODGE and with the main mounted bearing lines so your equipment runs smoothly again.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.