DODGE P2B-GTH-05-E pillow block bearing

DODGE P2B-GTH-05-E is a reference of pillow block bearing, within Bearing housings. Request a quote for P2B-GTH-05-E via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The DODGE GTH-E series Y-bearing unit with insert bearing is a mounted pillow block assembly that combines a cast iron housing with an insert ball bearing, already lubricated and sealed. It is used to support rotating shafts in power transmission equipment, where the bearing must be aligned, secured and protected in a single piece. MR Accesorios Industriales sells this line in Buenos Aires, Argentina, and advises you on choosing the correct part number for your application.

The GTH-E series designation is read in blocks. The initial letters P and B indicate the bearing unit type: pillow block with two mounting holes. The number that follows identifies the insert bearing size. The GTH block corresponds to the housing family and the -E suffix indicates the sealing variant. Thus, a P2B-GTH-06-E is a pillow block with size 06 insert, and a P2B-GTH-100-E is another size in the series.

These bearing units are seen in belt conveyors, bucket elevators, mixers, mills, screens and packaging lines. In Argentina they are common in food, cement, mining, paper and aggregate processing plants, where the environment has dust, moisture or frequent washdowns. The cast iron housing protects the insert and allows it to be fastened to the structure with two bolts, simplifying mounting and replacement in equipment that runs many hours per day.

To select the bearing unit, start from the shaft diameter and the load type: radial, axial or combined. Check that the insert has the right sealing for the environment — grease retained and contaminants kept out — and that the housing allows the necessary self-aligning movement. During mounting, rest the base on a flat, rigid surface, tighten the bolts in a cross pattern and check shaft alignment before starting up. The insert lubrication comes from the factory; subsequent regreasing depends on the working conditions.

Bearing units with insert bearing are interchangeable between brands if the shaft diameter, center height, hole spacing and mounting type match. Series with equivalent sealing suffixes can usually be replaced with each other, but it is advisable to confirm the thread, hole diameter and load rating before replacing a unit. If you have doubts, send the old part number and we will tell you the compatible alternative.

MR Accesorios Industriales sells the DODGE line in Buenos Aires, Argentina. If you need a GTH-E series bearing unit for your equipment, write to us on WhatsApp with the part number or model you are looking for and we will quote it shortly.