Take-up bearing DODGE NSTU-SCEZ-104S-SHCR

DODGE NSTU-SCEZ-104S-SHCR is a take-up bearing reference, within Bearing housings. Request a quote for NSTU-SCEZ-104S-SHCR via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The DODGE SCEZ Y-bearing take-up unit is a mounted take-up unit: it combines an insert ball bearing with a housing that allows it to be mounted on the shaft and fastened to the equipment. It is used to guide and tension shafts in conveyors, belts and power transmission systems, where radial loads must be absorbed and chain or belt tension corrected. MR Accesorios Industriales supplies it in Buenos Aires, Argentina.

The SCEZ series designation is read in blocks: the letters identify the Y-bearing take-up unit family and the housing type, while the central number indicates the shaft diameter for which it is made. The final suffix indicates sealing or insert configuration variants. An example from the series is NSTU-SCEZ-104S-SHCR, where the combination of prefix, series and suffix can be seen. To request a quote, send the full code as it appears on the equipment.

These units appear in belt and chain conveyors, packaging lines, mills, bucket elevators and transmission equipment in food, chemical and aggregate plants. In Argentina they are found in the field, in meatpacking plants and in waste treatment plants, always where there are rotating shafts with dust, humidity or frequent washdown. The housing allows them to be mounted on folded sheet metal structures or steel profiles without complex machining.

To select correctly, take into account the shaft diameter, the type of shaft fastening (set screw, eccentric or adapter) and the sealing: in environments with water or dust, an insert with a contact seal and flinger is advisable. Installation requires aligning the unit with the shaft, tightening the fastening evenly and lubricating according to the duty cycle. Excessive axial play or poor alignment shortens the life of the insert bearing.

Mounted units of this type are interchangeable between manufacturers if the shaft diameter, center height, mounting hole spacing and shaft fastening type match. Series with the same family letter usually share housing dimensions, but each case should be verified against the equipment drawing. If you need to replace a unit, send the code and the main dimensions.

If you have the code of the unit you are replacing, send it by WhatsApp to MR Accesorios Industriales along with the shaft diameter and a photo of the assembly. We will quote the DODGE reference or indicate the compatible alternative from the SCEZ series. We can also advise you on the sealing and lubrication suitable for the environment where the equipment operates.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.