DODGE INS-SXRH-200L insert bearing

DODGE INS-SXRH-200L is a reference of insert bearing, within Bearings. Request a quote for INS-SXRH-200L via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The DODGE SXRH series insert bearing is a ball bearing with an extended inner ring and set screw locking system, designed to be mounted in split plummer block housings and mounted bearing units. It is used in equipment that requires a rotating unit that is simple to install and replace, with good tolerance to misalignment and moderate radial loads. MR Accesorios Industriales sells this line in Buenos Aires, Argentina.

The SXRH series designation is read in parts: SXRH identifies the insert family of the Dodge Mounted Ball Bearings line, and the number that follows —as in INS-SXRH-200L— indicates the size within the series. The L suffix distinguishes the mounting or sealing variant. To order the correct replacement, provide the complete part number exactly as it appears on the nameplate or on the equipment drawing, because each combination defines the shaft diameter and the locking type.

These inserts are found in belt conveyors, bucket elevators, mixers, mills, centrifugal pumps and process equipment in food, chemical and aggregate plants. In Argentina they are common in packaging lines, plant conveyor belts and agricultural machinery. The advantage of the insert is that it allows the bearing to be replaced without changing the complete housing, which simplifies maintenance on equipment where the housing is already anchored to the structure.

To select the insert, take into account the shaft diameter, the locking type (set screws or eccentric), the sealing required according to the environment (dust, water, washdown) and the radial and axial load of the equipment. During mounting, check the alignment of the housing, clean the shaft seat and tighten the locking screws with a torque wrench according to specification. Factory lubrication is usually enough for the service life, but in severe environments it is best to check the condition of the seal and relubricate if the insert has a grease fitting.

As for equivalents, inserts are interchanged between brands by series number and shaft dimensions, but not all suffixes match: the same diameter may vary in width, sealing or locking system. So if you cannot find the exact part number, send us the shaft dimensions, the housing type and a photo of the part. At MR Accesorios Industriales we will indicate the compatible alternative or quote it to measure if needed.

To request a quote for your DODGE SXRH series insert bearing, write to us by WhatsApp with the complete part number —for example INS-SXRH-200L— or with the shaft dimensions and the housing type. We will reply shortly with the option that best suits your equipment.