Insert bearing DODGE AN-GT-06-102-CR

DODGE AN-GT-06-102-CR is a insert bearing reference, within Bearings. Request a quote for AN-GT-06-102-CR via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The DODGE GT series insert bearing is a ball bearing with an extended inner ring, designed to be mounted in split plummer block housings and wall units. It is used in equipment where radial loads and some axial thrust must be supported with flexible alignment. MR Accesorios Industriales sells this line as an official brand, with alternatives for different shaft sizes and sealing configurations.

The GT series designation is made up of the prefix AN, the GT code, a two-digit number indicating the shaft diameter and a numeric suffix identifying the sealing variant or locking type. For example, AN-GT-04-012-CR corresponds to an insert for a 3/4 inch shaft, while AN-GT-08-108-CR covers 1.1/2 inch shafts. The CR suffix appears in all references of the series and distinguishes the version with a contact seal. To choose the correct code, have the shaft size and the type of housing where it will be installed on hand.

These inserts are found in belt conveyors, bucket elevators, mixers, mills and process equipment in food, chemical and aggregate plants. In Argentina, they are common in the oilseed industry, waste treatment plants and packaging lines. Their format allows replacing the bearing without disassembling the entire housing, which reduces downtime. They are also used in industrial fans and low-speed transmission shafts.

To select the insert, verify that the shaft diameter matches the two-digit number in the designation and that the housing bore is compatible with the GT series. The CR seal is designed for environments with moderate dust or moisture; if the equipment undergoes frequent washdowns, additional protection should be evaluated. During mounting, align the housing and avoid striking the inner ring. Factory lubrication is usually sufficient for the service life, but in severe applications it is recommended to check the condition of the seal and renew the grease.

DODGE GT series insert bearings are interchangeable with other brands that manufacture inserts of equivalent dimensions, as long as the shaft diameter, inner ring width and locking system match. It is not enough for the code to be similar: the housing geometry and sealing type must be compared. If you need to replace an insert from another brand, send us the old code and shaft measurements, and we will indicate the compatible alternative.

If you already have the insert code or the equipment model, write to us on WhatsApp and we will quote you promptly. At MR Accesorios Industriales we work with the DODGE line and can guide you so the replacement is correct. Send us the complete reference, the shaft size and a photo of the housing if you have doubts.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.