Radial shaft seal DBH 9149 — 30.00 x 62.00 x 10.00

DBH 9149 is a radial shaft seal reference, within Seals. Request a quote for 9149 via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The DBH 9149 radial shaft seal is a lip seal that mounts in the housing and seals against the shaft to retain lubricant and block the entry of dust, water or particles. With dimensions of 30 mm shaft, 62 mm housing and 10 mm height, and Lx design, it is a common replacement part in gearboxes, pumps, electric motors and power transmission equipment. MR Accesorios Industriales carries this brand and helps you confirm the size before requesting a quote.

This item is a radial shaft seal from the DBH line, identified by the code 9149. Its dimensions are 30.00 mm shaft diameter, 62.00 mm housing diameter and 10.00 mm height. The Lx design corresponds to a single-lip seal with a metal case and sealing lip, intended for rotating shafts with lubrication. The Lx nomenclature defines the geometry of the lip and the body, not the material, which is confirmed against the manufacturer's data sheet.

It is used in equipment where a shaft rotates inside a fixed housing and oil or grease must be contained: gearboxes, centrifugal pumps, electric motors, rollers and conveyors. It also appears in applications exposed to dust or splashes, where the lip prevents the contaminant from reaching the bearing or bushing. It is a wear part: when the lip hardens or becomes marked, it starts to leak and should be replaced.

To install a seal of these dimensions, check that the shaft is clean, free of burrs and grooves, and lubricate the lip before inserting it. The housing must be sound and free of deformation; if the seal goes in crooked, the lip will not seal evenly. When selecting, in addition to the size, look at the shaft speed, the working temperature and the fluid to be retained: that determines whether the standard compound is sufficient or another one is needed. The 10 mm height leaves little margin for installation errors.

If code 9149 does not appear or you need a nearby size, send us the shaft diameter, the housing diameter and the height you measured, plus a photo of the old seal and the housing. With that data we look for the equivalent in DBH or in another line we carry, always respecting the size and the lip type. You do not need to have the code on hand: the actual measurement is what matters.

To request a quote for the DBH 9149 oil seal, write to us on WhatsApp with the code 9149 or with the dimensions 30 x 62 x 10 mm. At MR Accesorios Industriales we confirm the quote and the alternative if it is not exactly that code. We can also advise you on installation and housing care so the seal lasts as long as it should.