Radial shaft seal DBH 9035 — 10.00 x 21.00 x 7.00

DBH 9035 is a radial shaft seal reference, within Seals. Request a quote for 9035 via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The DBH 9035 radial shaft seal is a lip seal that blocks the passage of oil or grease between a rotating shaft and its housing. With a 10 mm shaft diameter, 21 mm housing diameter and 7 mm height, it is used in gearboxes, pumps, electric motors and power transmission equipment. Its Lx design combines a sealing lip with a metal body that is press-fitted into the cavity. MR Accesorios Industriales carries this brand and helps you choose the right size.

The DBH 9035 is a radial shaft seal with an Lx design, intended for shafts with a diameter of 10 mm, housings of 21 mm and a total height of 7.00 mm. The flexible lip runs on the shaft surface and keeps the lubricant inside the assembly, while the outer body is press-fitted into the housing. This combination of dimensions corresponds to a compact section, common in equipment where axial space is limited. The 9035 designation identifies the size within the DBH line and should be verified against the manufacturer's data sheet before ordering.

Typical applications for this seal include small gearboxes, centrifugal pumps, low-power electric motors, spindles and transmission mechanisms. It also appears in equipment in the food, textile and packaging industries, where oil or grease must be contained without contaminating the environment. In all cases, the seal works alongside a bearing or bushing that supports the shaft, and its function is to prevent leaks and the entry of dust or water into the mechanism.

To install a seal such as the DBH 9035, take the condition of the shaft into account: the surface where the lip rests must be polished and free of burrs, with suitable hardness and roughness. The housing must be clean and free of deformation, and the seal is inserted with a flat tool that presses on the metal edge, never on the lip. Before installing it, lubricate the lip with the same grease or oil used in the equipment. If the shaft shows wear, consider a nearby size or a repair sleeve.

If you need an equivalent or a size close to the 9035, the most practical approach is to measure the shaft diameter, housing diameter and height with a caliper, and send those three values along with the part number. At MR Accesorios Industriales we can compare with other seal series from the same brand or from alternative manufacturers, always respecting the mounting tolerances. We can also advise you if the original seal has a special design, such as a double lip or a dust guard.

To request a quote for the DBH 9035 seal or ask about an equivalent size, write to us on WhatsApp and send us the part number, the dimensions or a photo of the part. At MR Accesorios Industriales we work with seals for different applications and will reply with the option that best suits your equipment. Remember that the 9035 designation is the exact reference: with that data we can confirm alternatives.