Radial shaft seal DBH 5063Sil — 25.00 x 62.00 x 10.00

DBH 5063Sil is a radial shaft seal reference, within Seals. Request a quote for 5063Sil via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The DBH 5063Sil seal is a single-lip radial seal that mounts on rotating shafts to retain lubricant and block the entry of dust, water or particles. Its Lz design and its dimensions of 25 mm shaft, 62 mm housing and 10 mm height make it a common replacement part in gearboxes, pumps and electric motors. At MR Accesorios Industriales we carry it as part of our line of seals and oil seals for industrial maintenance.

This item is a DBH 5063Sil radial shaft seal, identified by its commercial designation. Its published attributes are: shaft diameter 25 mm, housing diameter 62 mm, height 10 mm and Lz design. The Lz design corresponds to a spring-loaded sealing lip that runs on the shaft and an outer case that is press-fitted into the housing. The 10 mm height defines the total width of the seal and determines the depth of the housing where it is installed.

Typical applications for a seal of this size include gearboxes, centrifugal pumps, electric motors, conveyor rollers and power transmission equipment. In all cases it serves to confine the oil or grease inside the assembly and prevent contaminants from entering from outside. It is a wear part that is replaced during preventive or corrective maintenance tasks, especially when visible leaks or bearing noise appear.

To install it, check that the shaft has no burrs or deep marks in the contact area and that the housing is clean and free of deformation. Lubricate the lip before inserting it and place the seal perpendicular to the shaft, without hitting it directly. The choice of the Lz design responds to rotating conditions with permanent lubrication; if the equipment works with a lot of dirt or at high speeds, it is advisable to consider variants with a dust lip or specific materials.

If you need an equivalent or a nearby size, the most practical thing is to send us the code engraved on the old seal or the dimensions taken with a caliper: shaft diameter, housing diameter and height. With that data we can look for an alternative within the same category or suggest a compatible replacement. We can also advise you if the housing accepts a seal of a different height or if a design with an additional lip is needed.

To request a quote for the DBH 5063Sil seal or ask about a similar size, send us the code on WhatsApp at MR Accesorios Industriales. We will reply with the quote and the alternatives that best fit your equipment. We work with more than 80 years of experience in the field and advise factories, plants and industrial maintenance teams in the selection of seals and oil seals.