Radial shaft seal DBH 5035 — 52.40 x 81.00 x 11.50

DBH 5035 is a radial shaft seal reference, within Seals. Request a quote for 5035 via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The DBH 5035 radial shaft seal is a lip seal designed to stop lubricant from escaping and prevent contaminants from entering equipment with a rotating shaft. Its dimensions of 52.40 mm shaft diameter, 81.00 mm housing diameter and 11.50 mm height make it suitable for gearboxes, pumps and motors where space is limited. MR Accesorios Industriales supplies this official brand and advises you so you can choose the right seal for your application.

This item is a DBH 5035 radial shaft seal, identified by its designation 5035. Its main attributes are: shaft diameter (d) of 52.40 mm, housing diameter (D) of 81.00 mm and height (h) of 11.50 mm. The Kx design corresponds to a configuration with a sealing lip and spring, intended to retain oil or grease on rotating shafts. DBH is an official brand that MR supplies, so you can ask us about equivalent alternatives.

Typical applications for a seal of these dimensions include gearboxes, centrifugal pumps, electric motors, rollers and power transmission equipment. In every case, its function is to keep the lubricant inside the assembly and block dust, water or particles that could damage the bearings. It is a wear part that should be checked during every preventive maintenance service, especially if there are visible leaks or noise at the shaft.

To install a radial shaft seal, check that the shaft diameter and the housing match the dimensions indicated. The shaft surface must be polished and free of burrs; it is advisable to lubricate the lip before inserting it and to use an installation tool that presses on the outer ring, never on the lip. If the equipment runs at high speed or high temperatures, ask us about the lip material and the type of spring, so we can select the most suitable variant.

If you need an equivalent seal or a nearby size, the most practical approach is to send us the code 5035 or the current dimensions (shaft diameter, housing and height). With that data we can look for an alternative within the same series or from another brand we supply. We can also advise you if the mounting space allows a seal with a greater or smaller height, always respecting the housing tolerances.

To request a quote for the DBH 5035 seal or ask about a replacement, send us the code on WhatsApp at MR Accesorios Industriales. We reply with the options and the technical data you need to confirm that it is the right seal for your equipment. More than 80 years serving industry allow us to advise you with technical judgment and no runaround.