Tapered roller bearing cup TIMKEN H917810

TIMKEN H917810 is a tapered roller bearing cup reference, within Bearings. Request a quote for H917810 via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The cup is the outer ring of a tapered roller bearing: a tapered raceway that is mounted in the housing and works together with the cone (inner ring with rollers and cage). It supports combined radial and axial loads, which is why it is used in gearboxes, wheel axles, lifting machinery and transmission equipment. MR Accesorios Industriales supplies the TIMKEN line with standardized sizes and equivalent alternatives for each application.

The designation of this series starts with the letter H followed by a numeric block that identifies the size and design of the cup. In the examples H238110, H239610, H242610 or H247510 the number that defines the outer diameter and the width of the raceway changes. The suffixes, when they appear, indicate variants of tolerance, angle or treatment; that is why it is advisable to provide the complete part number when requesting a quote.

In Argentine industry, these cups are found in gearboxes, axles and hubs of heavy vehicles, mills, conveyor belts, presses and road equipment. Also in agricultural machinery, where the tapered roller tolerates slight misalignments and impact loads. As it is a replacement component, the cup is usually ordered together with the corresponding cone to maintain the original torque and avoid premature failures.

To select correctly, take into account the outer diameter and the width of the cup, the contact angle and the type of sealing of the assembly. Installation is done by fit in the housing, with a press or controlled heating, never by striking the raceway. Lubrication must be adequate for the speed and temperature, and alignment between cup and cone is key so that the rollers work without loaded edges.

TIMKEN is a world reference in tapered rollers and its sizes respond to widely disseminated standards. There are equivalences between manufacturers for many series, but they are not automatic: tolerances, angles and radii change. If you need to replace a cup, send us the original part number and at MR Accesorios Industriales we will indicate the compatible alternative or manufacture it to measure if applicable.

If you have the cup part number, the cone number or the housing size, write to us by WhatsApp. We will quote you promptly and advise you so that the cup-cone assembly is properly matched. We can also review applications with combined loads or demanding speeds to guide you on the most suitable installation and lubrication.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.