SKF PHG AX40.5EP v-belt

SKF PHG AX40.5EP is a reference of v-belt, within Power transmission. Request a quote for PHG AX40.5EP via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The SKF AX section V-belt, classic cogged type, is a power transmission element mounted on grooved pulleys to link motor and machine. Its V profile and molded cogs allow it to transmit torque with good grip and dissipate heat in continuous service. It is used in equipment where space is limited and stable running is required. MR Accesorios Industriales sells it in Buenos Aires, Argentina, and advises you on choosing the right size.

The designation of this line starts with PHG, which identifies the category of classic cogged V-belts. It is followed by the AX section, which defines the width and height of the profile: it is one of the sections of the classic series. Then comes a number that indicates the outside length in inches, as in PHG AX20.25EP or PHG AX22.5EP. The EP suffix indicates a compound and construction variant within the same category. With that data you can locate the belt you need without ambiguity.

In Argentine industry, AX section belts appear in machine tools, small compressors, centrifugal pumps, low-power fans and factory equipment. They are also seen in agriculture, in seeders and sprayers, and in food plants where there are low-power motors with small-diameter pulleys. Being cogged, they tolerate work on small pulleys better and help maintain speed when mounting space is limited.

To select well, take into account the motor power, the rotation speed and the pulley diameter. The AX section requires pulleys with a compatible groove; if the groove is worn, the belt slips and heats up. Check the alignment between pulleys with a straightedge or laser: a misalignment of a few degrees shortens service life. Tension is adjusted according to the equipment manual: too loose it slips, too tight it punishes the bearings. Check the condition of the belt from time to time and change it if you see cuts or wear.

When replacing, always compare the complete designation. The AX section may appear in other brands with similar nomenclatures, but not all belts of the same length are interchangeable: the compound, the cogging and the dimensional tolerance change. If the original equipment came with an SKF belt, the safest thing is to replace it with the same reference. If you cannot find it, send us the old code and the pulley measurements, and from MR Accesorios Industriales we will help you find the equivalence.

To get a quote, send us by WhatsApp the complete code that appears on the belt, for example PHG AX23.5EP, or the designation that appears in the equipment manual. You can also send us a photo of the old belt and the pulley measurements. With that data we will send you the quote. We serve factories, industries and individuals in Buenos Aires, Argentina, and ship throughout the country.