Pillow block bearing SEALMASTER SP-207

SEALMASTER SP-207 is a pillow block bearing reference, within Bearing housings. Request a quote for SP-207 via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The SP pillow block with SEALMASTER insert bearing is a mounted pillow block unit: it combines a cast iron housing with an insert bearing, pre-assembled and factory-lubricated. It is used to support rotating shafts in conveyors, fans, mixers and power transmission equipment, where rigidity and alignment are required. MR Accesorios Industriales supplies this line in Buenos Aires, Argentina, with more than 80 years of experience in bearings and industrial accessories.

The SP designation identifies the series of pillow blocks with insert bearing. The number that follows — for example SP-13, SP-14 or SP-15 — indicates the size of the insert and housing. The higher the number, the larger the shaft diameter and load capacity. Any suffixes that may appear after the number indicate variations in sealing, locking or insert material. To choose the right one, provide the complete code shown on the equipment nameplate or drawing.

These pillow blocks are found in belt conveyors, bucket elevators, exhaust fans, mixers, screens and packaging lines. In Argentina they are common in food plants, cement plants, cold storage facilities and grain warehouses, where the environment has dust, moisture or frequent washdowns. The pillow block unit allows the shaft to be mounted on a flat base and absorbs moderate radial and axial loads without machining a special housing.

To select correctly, consider the shaft diameter, radial and axial load, and environmental conditions. The insert seal determines whether it is suitable for dust, water or high-pressure washdown. Lubrication is factory-applied, but in service it should be checked according to the duty cycle. During installation, place the pillow block on a clean, flat surface, tighten the mounting bolts and verify shaft alignment before start-up.

SEALMASTER SP pillow blocks are interchangeable with other mounted units of equivalent dimensions, provided the shaft diameter, locking type and pillow height match. It is not enough for the number to be similar: the housing geometry and insert locking system must be compared. If you need to replace an existing unit, send us the code stamped on the pillow block or the shaft and base dimensions.

MR Accesorios Industriales supplies the SEALMASTER line in Buenos Aires, Argentina. If you are looking for an SP pillow block for your equipment, write to us via WhatsApp with the code or model you need: we will quote it promptly. We can also indicate the compatible alternative if your application requires a different sealing or locking configuration.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.