SEALMASTER PVR-1626 flange bearing 2 holes

SEALMASTER PVR-1626 is a reference of flange bearing 2 holes, within Bearing housings. Request a quote for PVR-1626 via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The SEALMASTER PVR series Y-bearing insert unit is a two-bolt flange mounted bearing, designed to secure rotating shafts to flat structures with simple alignment and quick mounting. It is used in equipment where the shaft must be supported and protected, with the ability to compensate for minor misalignment. MR Accesorios Industriales sells this line and advises you on choosing the right part number for your application.

The PVR series designation reads as a catalogue code: the letters identify the two-bolt flange housing family and the number that follows, as in PVR-1605, PVR-1608, PVR-1612, PVR-1615, PVR-1624, PVR-1626, PVR-3647 or PVR-3648, refers to the combination of housing and insert bearing dimensions. Each numeric suffix distinguishes shaft diameters and hole spacing; that is why, to order the correct replacement, the most practical approach is to provide the complete part number shown on the part or on the equipment drawing.

These housings are found in conveyors, belts, elevators, mixers, blowers and process lines in food, chemical, cement and aggregate processing plants. In the Argentine market they are common in equipment operating in dusty, humid or frequently washed environments, where a compact unit that bolts onto a plate or frame and allows quick replacement without dismantling the whole assembly is required.

To select correctly, take into account the shaft diameter, the flange hole spacing and the type of sealing the environment requires. The insert usually comes with set screws or an eccentric locking system; check that the shaft is clean and free of burrs, and that the flange sits flat on the surface. Proper lubrication and a fit without impacts extend bearing life and prevent noise or vibration.

As for equivalences, two-bolt flange housings are interchangeable between brands if the mounting dimensions and shaft diameter match, although the sealing, internal clearance or locking type may vary. There is no universal table: it is best to compare drawing against drawing. If you need to replace a SEALMASTER with another brand, at MR we indicate the compatible alternative with the same critical dimensions.

If you already have the part number of the housing you are using, send it by WhatsApp to MR Accesorios Industriales along with a photo or the flange drawing. With that data we quote the corresponding SEALMASTER reference or, if necessary, the equivalent option. We can also advise you on mounting and lubrication so the unit works under the best conditions.