Insert bearing SEALMASTER LS-116

SEALMASTER LS-116 is a insert bearing reference, within Bearings. Request a quote for LS-116 via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The SEALMASTER LS 100 series insert bearing is a single-row ball bearing with an extended inner ring, designed to be mounted in split or solid housings to form bearing units for rotating shafts. It is used in equipment where radial loads and some axial thrust must be supported with simple alignment. MR Accesorios Industriales supplies this line in Buenos Aires, Argentina, and quotes it on WhatsApp with the exact part number.

The LS 100 series designation is read with the LS prefix and a three-digit number that identifies the shaft diameter: for example, LS-108, LS-110 or LS-112. The suffixes shown in the catalogue indicate variants of sealing, locking or outer ring configuration. To choose the correct part number, send us the full number shown on the nameplate or drawing, and at MR we will indicate the equivalent reference.

These inserts are mounted in pillow block, flange or take-up housings and are found in belt conveyors, packaging lines, mixers, centrifugal pumps, fans and process lines in food, chemical and materials plants. In Argentina they are common in material handling equipment and in machines operating with moderate drive shafts. The LS 100 series covers a range of sizes that is repeated across several brands, which makes replacement easier.

To select correctly, take into account the type of sealing required by the environment: if there is dust, water or frequent washdowns, an insert with reinforced contact seals is advisable. Also check lubrication: these bearings come pre-lubricated and require no maintenance until replacement. During mounting, make sure the shaft is clean and free of burrs, and that the housing is aligned so as not to load the insert unevenly. If the equipment operates with misalignment, the appropriate housing absorbs that movement.

As for equivalents, SEALMASTER LS 100 series inserts interchange with equivalent lines from other brands that use the same diameter and configuration nomenclature. There is no universal table: interchangeability depends on shaft diameter, inner ring width and locking type. If you send us the original part number, at MR Accesorios Industriales we will indicate the compatible alternative from our catalogue.

If you need to replace a SEALMASTER LS 100 insert bearing, write to us on WhatsApp with the full part number (for example, LS-108 or LS-115) and we will quote it shortly. We can also advise you if the housing or shaft have particularities worth reviewing before purchasing.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.