REXNORD ZPS6110MMF flange bearing 4 holes

REXNORD ZPS6110MMF is a reference of flange bearing 4 holes, within Bearing housings. Request a quote for ZPS6110MMF via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

REXNORD ZPS series 4-bolt flange mounted bearings are units that combine a bearing and its housing in a single assembly. This type includes part numbers such as ZPS6080MMF, ZPS6100MMF and ZPS6125MMF. Each number is a different unit size, and the MMF suffix is part of the part number.

The four-bolt flange is bolted against a flat surface perpendicular to the shaft, such as the front of a machine, a frame or a closing plate. The four mounting points distribute the load and give the unit stable support. A mounted unit arrives as an assembly, which simplifies installation and replacement compared with assembling the bearing and housing separately.

The part numbers of this type start with ZPS, followed by four digits (6080, 6100, 6125, among others) and end in MMF. The numbers advance in steps, and each step is a different unit size. The MMF suffix must not be confused with MM, which corresponds to another unit type; that is why the full part number is given.

Selection depends on four data points: shaft diameter, distance between mounting holes, load and working conditions. If you are replacing an existing unit, read the full part number engraved on it or take the measurements of the assembly; that is enough to identify the replacement.

During installation, clean the support and the shaft, slide the unit in without striking it and fasten it with even tightening. Check that it turns freely and without noise before starting the machine. Always follow the manufacturer's instructions to secure the unit to the shaft and to grease it.

To request a quote, write to us on WhatsApp or by email with the full part number, for example ZPS6100MMF, and the quantity. If you have the unit you are removing, add a photo. We reply promptly, from Buenos Aires, Argentina.