Flange bearing 3 holes REXNORD ZBS5035MM

REXNORD ZBS5035MM is a flange bearing 3 holes reference, within Bearing housings. Request a quote for ZBS5035MM via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The Rexnord ZBS series 3-bolt flange bearing is a mounted bearing with a flange housing, designed to secure rotating shafts onto walls, frames or flat structures. The three-bolt flange distributes the load evenly and allows the unit to be aligned on the mounting plane. It is used in equipment where the shaft must sit perpendicular to the supporting surface, with the unit already assembled and ready to install.

The ZBS series designation is read in blocks: the letters ZBS identify the 3-bolt flange housing family, and the digits that follow indicate the unit size within the series. In the examples ZBS5035MM and ZBS6035MM, the first numeric block refers to the housing series (5000 or 6000) and the MM suffix indicates the sealing and mounting configuration variant. To request a quote, send us the complete part number exactly as it appears on the equipment.

In Argentine industry these housings appear in belt and screw conveyors, bucket elevators, mixers, screens and process lines in food, cement and chemical plants. They are also found in water treatment equipment, blowers and induced draft fans. The 3-bolt flange simplifies mounting onto sheet metal or profile structures, where there is not always room for a full base.

To select the right unit, take into account the radial and axial load the shaft will bear, the diameter and length of the span between supports, and the type of sealing the environment requires: a clean tank is not the same as an area with dust, humidity or frequent washdown. During mounting, check that the supporting surface is flat and clean, tighten the three bolts gradually and in a cross pattern, and check shaft alignment before starting up the equipment. Lubrication and internal clearance are defined by the application and the duty cycle.

When replacing a unit, always compare the complete part number and not just the shaft diameter: two housings with the same size can differ in bolt pattern, center height or sealing type. Between brands, interchangeability is resolved by cross-referencing the original manufacturer's designation with that of the replacement and verifying the critical flange dimensions. If the part number does not appear in the equipment catalogue, send us a photo of the part and the shaft size.

At MR Accesorios Industriales we carry the Rexnord line and quote the housing you need. Write to us on WhatsApp with the complete ZBS part number, the equipment series or a photo of the mounted unit: we will tell you the corresponding reference and the compatible alternative if needed. With more than 80 years in the business, we support the selection and replacement of mounted bearings in plants across the country.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.