REXNORD P2BRN126110MMZE pillow block bearing

REXNORD P2BRN126110MMZE is a reference of pillow block bearing, within Bearing housings. Request a quote for P2BRN126110MMZE via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The Rexnord Y-bearing pillow block is a foot-mounted assembly that combines a cast iron housing with a self-aligning insert bearing, ready to be fixed to a structure and receive a rotating shaft. It is used in equipment where the shaft must be supported and aligned without machining the seat, such as conveyor belts, elevators, agitators and process machinery. MR Accesorios Industriales sells this line in Buenos Aires, Argentina, and advises you on choosing the correct variant according to the shaft and load.

The designation of these housings is read in blocks: the initial letter P indicates the foot configuration, the first number after the P indicates the nominal shaft diameter in inches, and the following block combines the housing type with the outside diameter and width. In the series examples, the middle digits change according to the shaft size and the housing, while the final suffixes identify the sealing and mounting variants. The 2000, 5000 and SHURLOK series group different insert families within this same nomenclature.

These housings are seen in food and beverage plants, cement plants, paper mills, water treatment plants and packaging lines. In Argentina they are common in belt conveyors, bucket elevators, mixers, blowers and process equipment where the shaft rotates at moderate speeds and the housing is bolted to a frame. The advantage of the Y-bearing pillow block is that the insert bearing self-aligns within the housing, which absorbs small mounting deviations and simplifies maintenance.

To choose the correct housing, take into account the shaft diameter, the insert fixing type (set screw, eccentric or with adapter sleeve) and the sealing required by the environment: an area with abrasive dust is not the same as frequent washing. Mounting requires a flat, clean surface, screws tightened in a cross pattern and adequate lubrication before start-up. If the shaft has little support or there are axial loads, it is advisable to check the alignment and the insert clearance before fixing the housing.

In the market, housings from different brands with standardized dimensions coexist, and in many cases a housing from another source can replace the original if the shaft diameter, the distance between holes and the center height match. This interchangeability is not always direct: the seals, the fixing system and the load capacity change. Therefore, when you look for an equivalent, send the complete code and the shaft dimensions so that we can indicate the compatible alternative.

MR Accesorios Industriales sells the Rexnord line of Y-bearing pillow blocks in Buenos Aires, Argentina. If you need a size you do not see or want to confirm the variant for your equipment, send the code or model via WhatsApp and we will quote you shortly. We can also advise you on mounting and lubrication so that the housing works under the correct conditions.