Flange bearing 4 holes REXNORD KLFSS2M35

REXNORD KLFSS2M35 is a flange bearing 4 holes reference, within Bearing housings. Request a quote for KLFSS2M35 via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The Rexnord KLF-SS200 series 4-bolt flange bearing housing is a mounted bearing ready to be fastened to a flat surface with four bolts. It is used to support rotating shafts in equipment where firm fastening and simple alignment are required, such as conveyor belts, mixers, fans and process machinery. Its flange design allows it to be mounted facing a wall or a frame, with the shaft passing through or at the end depending on the application.

The KLF-SS200 series designation is read in blocks: KLF identifies the 4-bolt flange housing, SS indicates stainless steel construction and 200 corresponds to the dimensional series of the insert bearing. The number that follows the M in each reference — for example KLFSS2M25, KLFSS2M30, KLFSS2M35 or KLFSS2M40 — indicates the shaft diameter for which the insert is machined. Thus, the same flange accepts different shaft diameters within the series, and the M suffix distinguishes the type of insert-to-shaft fastening.

In Argentine industry these housings appear in food and beverage, water treatment, chemical and petrochemical plants, and in material handling equipment. They are found in belt and chain conveyors, bucket elevators, agitators, centrifugal pumps, air extractors and dryers. The stainless steel version is chosen when there is frequent washing, ambient humidity or contact with corrosive products, because it resists oxidation better than a painted cast iron housing.

To select the housing, start from the shaft diameter and the type of load: radial, axial or combined. Verify that the flange has the adequate number of holes and bolt diameter for your frame. During mounting, place the flange on a clean, flat surface, tighten the bolts in a cross pattern and check shaft alignment with a straightedge or dial indicator. If the environment has dust or water, choose the insert seal accordingly; for high temperature or speed, follow the lubrication indicated by the bearing manufacturer.

Mounted housings are interchanged between brands by shaft number and flange dimensions, but not all series share the same center height or hole pattern. Before replacing one housing with another from a different manufacturer, compare the shaft diameter, distance between holes, bolt circle diameter and center height. If space is limited, it may be necessary to adapt the flange or choose an equivalent series from another manufacturer.

If you need a flange housing for your equipment, send by WhatsApp the part number on the part or the shaft diameter and number of holes. At MR Accesorios Industriales we will quote the corresponding Rexnord KLF-SS200 reference and, if you are looking for another variant, we will indicate the compatible alternative. We also manufacture split plummer block housings and custom parts for special cases.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.