NTN UKP208D1 pillow block bearing

NTN UKP208D1 is a reference of pillow block bearing, within Bearing housings. Request a quote for UKP208D1 via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The UKP2 housing with NTN insert bearing is an assembled foot-mounted unit that combines a cast iron housing with a UK series insert bearing. It is used to support shafts in belt, chain or coupling drives where simple alignment and fastening are required. MR Accesorios Industriales sells this line in Buenos Aires, Argentina, in industrial distribution.

The UKP2 designation reads as follows: UK identifies the insert bearing with taper sleeve and set screws, P indicates the split pillow block housing, and the number that follows indicates the size of the insert and the housing. The D1 suffix corresponds to the sealing and fastening variant that NTN applies to this series. Thus, the different part numbers share the same format but change the shaft diameter. To choose, send us the full part number or the shaft size.

These housings are found in belt conveyors, bucket elevators, mixers, screens and packaging lines. Also in the field: screw conveyors, water wheels and mills. In Argentina they are common in food, cement and mining plants and in the agro-industrial sector, where foot mounting makes maintenance easier without disassembling the entire shaft. The cast iron housing absorbs radial loads well and allows the housing to be fastened to a flat base with two bolts.

To select, take into account the shaft diameter, the radial load and whether there is axial load: the UK insert with taper sleeve is fastened to the shaft by means of a lock nut and lock washer, which simplifies mounting and dismounting. Check the alignment of the base and the parallelism between housings. Lubrication comes from the factory; in service, grease through the fitting according to the duty cycle. The D1 seal protects against dust and splashes, although in very dirty environments additional seals should be evaluated.

As for equivalents, NTN UKP housings are interchangeable with those of other brands that use the same mounting standard and shaft sizes. If you bring a part number from another company or an unidentified part, at MR Accesorios Industriales we will tell you the compatible alternative. Interchangeability is based on the shaft diameter and the type of insert, not on the commercial part number. That is why it is best to send a photo or the part number engraved on the housing.

If you need a UKP with insert bearing, write to us via WhatsApp with the part number or the shaft size. We will send your quote shortly. We work with the NTN line and can advise you on the variant that best suits your equipment. MR Accesorios Industriales, Buenos Aires, Argentina.