Flange bearing 3 holes NTN AELPF203-011W3

NTN AELPF203-011W3 is a flange bearing 3 holes reference, within Bearing housings. Request a quote for AELPF203-011W3 via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The NTN AELPF2 series Y-bearing insert unit is a 3-bolt flange unit that combines an insert bearing with a cast iron housing. It is used to mount rotating shafts on flat structures, with the flange bolted down and the shaft passing through. It is a compact, self-aligning solution for equipment where the housing must be flanged to a sheet metal panel or casing. MR Accesorios Industriales sells this series in Buenos Aires, Argentina.

The AELPF2 designation is read in parts: AEL identifies the insert bearing with set screws, PF indicates the 3-bolt flange housing and 2 the dimensional series. The numeric suffixes that follow the base code, as in AELPF201-008W3 or AELPF204-012W3, indicate the shaft diameter and the fastening type. The W3 ending corresponds to a specific sealing and fastening variant of the series. Each combination of letters and numbers defines a unit ready for mounting.

These housings are used in belt conveyors, packaging lines, mixers, fans and process lines in food, chemical and materials plants. In Argentina they appear in grain handling equipment, feed plants and transmission systems in general. The 3-bolt flange allows them to be fastened to folded sheet metal frames or profile structures, with the shaft supported in the insert bearing. It is a common unit in machines requiring rigid, low-maintenance support.

To select the unit, take into account the shaft diameter, the insert fastening type (set screws or eccentric) and the sealing required for the environment. Mounting requires resting the flange on a flat, clean surface, tightening the fastening bolts and checking shaft alignment before start-up. The insert is lubricated with compatible grease and the seal protects against dust and moisture. Check axial and radial play after mounting to avoid parasitic loads.

Insert bearing housing units are interchangeable between manufacturers if the flange dimensions, shaft diameter and fastening type match. When replacing an NTN unit with another brand, compare the distance between holes, the flange diameter and the shaft center height. If the insert has the same diameter and fastening system, the swap is direct. For accurate equivalents, send us the original part number and we will indicate the compatible option.

If you need a quote for an NTN AELPF2 series Y-bearing insert unit, write to us on WhatsApp with the part number or shaft size. At MR Accesorios Industriales we quote the exact reference and advise you on installation. We can also help you identify the unit from a used part or a drawing. Send your inquiry and we will reply promptly.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.