NSK UKFL210D1;HA2310 flange bearing 4 holes

NSK UKFL210D1;HA2310 is a reference of flange bearing 4 holes, within Bearing housings. Request a quote for UKFL210D1;HA2310 via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The UKFL housing with NSK insert bearing is a four-bolt flanged unit that combines a cast iron housing with a UK series insert bearing. It mounts on shafts by means of an adapter sleeve, which simplifies adjustment and allows it to transmit moderate radial and axial loads. It is used in transmission, conveying and process equipment where firm support and simple mounting are required. MR Accesorios Industriales sells it in Buenos Aires, Argentina.

The UKFL designation reads as a flanged unit with a UK series insert bearing. The letters UK identify the bearing with taper sleeve, FL indicates the four-bolt square flange, and the number that follows —209, 210, 211, 213, 215, 216, 309, 310— indicates the shaft diameter for which the unit is intended. The suffix D1 corresponds to the insert design, and the accompanying HA code identifies the adapter sleeve that completes the mounting on the shaft.

These units are used in belt conveyors, elevators, mixers, fans, pumps and agricultural or food machinery. In the Argentine market they appear in milling plants, meat processing plants, water treatment plants and packaging lines, where the four-bolt flange makes anchoring to steel structures or masonry easier. The combination with an adapter sleeve allows mounting on shafts without machined shoulders, which is useful in existing equipment or in repairs where the shaft is already in service.

To select the unit, take into account the shaft diameter, the type of load and the environmental conditions. The insert seal defines the protection against dust and moisture: choose the appropriate design if the equipment works outdoors or with frequent washdowns. The HA sleeve is tightened with a precision nut; check the flange alignment and axial clearance before start-up. The insert is lubricated through the built-in grease fitting, at the frequency indicated by the manufacturer according to speed and operating temperature.

UKFL units from different brands share standardized flange dimensions and shaft diameters, so they are often interchangeable between manufacturers. If you are replacing an existing unit, compare the hole spacing, the flange diameter and the type of sleeve. To identify a part without a code, the main dimensions and a photo are enough. At MR Accesorios Industriales we quote the exact code or size you need, and if the equipment requires a variant, we handle it with the manufacturer.

If you already have the unit code —for example, UKFL210D1 with HA2310 sleeve—, send it by WhatsApp to MR Accesorios Industriales and we will quote it promptly. You can also ask about other sizes in the UKFL series or equivalent units from other brands. At MR Accesorios Industriales we handle technical and commercial inquiries about housings and insert bearings for the entire Argentine industry.