LINK-BELT ZPS5035MM pillow block bearing

LINK-BELT ZPS5035MM is a reference of pillow block bearing, within Bearing housings. Request a quote for ZPS5035MM via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

LINK-BELT ZPS series pillow block bearings are units that combine a bearing and its housing in a single assembly. This type includes part numbers such as ZPS5035MM, ZPS6060MM and ZPS6075MM. The numbers change with each part number, and so do the unit's dimensions.

The pillow block has a base with mounting holes and rests on a surface parallel to the shaft, such as a beam, a machine table or a frame. It is the most common form when there is a support plane below the shaft. A mounted unit arrives as an assembly, which simplifies installation and replacement compared with assembling the bearing and housing separately.

Part numbers of this type start with ZPS, followed by four digits (5035, 5075, 6035, 6075, among others) and end in MM. Within each group the numbers advance in regular steps, and each step corresponds to a unit of a different size. The MM suffix must not be confused with MMF, which belongs to another type of unit.

When choosing a unit of this type, check the shaft diameter, the support surface and the environment where it will work. A worn or out-of-tolerance shaft affects any bearing, so it is best to measure it before installing the replacement.

For installation, make sure the support surface is flat and that the shaft is aligned with the unit. Tighten the bolts in a crosswise, even pattern, then turn the shaft by hand to confirm there are no hard spots. Any questions about shaft mounting are answered by the manufacturer's data sheet.

To request a quote, send us by WhatsApp or email the full part number, such as ZPS6060MM, with the quantity you need. A photo of the installed unit helps confirm. We reply promptly, from Buenos Aires, Argentina.