Pillow block bearing LINK-BELT ZAF6100MMF

LINK-BELT ZAF6100MMF is a pillow block bearing reference, within Bearing housings. Request a quote for ZAF6100MMF via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

LINK-BELT ZAF Series 6000 pillow blocks are mounted units that combine an insert bearing with a pillow block housing, ready to be fastened to the structure and receive the shaft. They are used to support drive shafts in equipment where rigid support and simple mounting are required, with self-alignment of the insert. MR Accesorios Industriales carries this line as an official brand and advises you on choosing the correct size for your application.

The ZAF#MMF designation is read in parts: ZAF identifies the pillow block family, the number that follows (6060, 6065, 6070, 6075, 6080, 6085, 6090, 6100) indicates the size of the assembly, and the MMF suffix distinguishes the sealing and locking variant. The 6000 series groups these sizes, and each complete code —for example ZAF6060MMF or ZAF6100MMF— defines a unit with its own shaft and housing dimensions. To request a quote, send us the exact code shown on your equipment or on the housing nameplate.

These pillow blocks are used in conveyors, bucket elevators, mills, mixers, pumps and industrial fans. In the Argentine market they appear in food, cement and chemical plants and in process lines where the shaft rotates at moderate speeds and loads are mainly radial. The pillow block housing allows them to be mounted on bases or steel structures, and the insert accommodates small angular misalignments, which simplifies installation on existing equipment.

To select the pillow block, take into account the shaft diameter, the radial and axial load it will support, and the environmental conditions. The insert seal defines the protection against dust, water or particles: in dirty environments a variant with a reinforced seal is advisable. Mounting requires the base to be supported over its entire surface and the shaft to be aligned with the insert before tightening the bolts. Proper lubrication and periodic re-tightening extend the life of the assembly.

LINK-BELT Series 6000 pillow blocks can be interchanged with equivalent units from other brands that share shaft dimensions, hole spacing and center height. Interchangeability does not depend only on shaft diameter: the housing geometry and the type of locking must be verified. If you need to replace an existing pillow block, send us the complete code or the main dimensions and we will indicate the compatible alternative.

MR Accesorios Industriales carries the LINK-BELT line as an official brand and brings more than 80 years of experience in industrial distribution. If your equipment requires a ZAF Series 6000 pillow block, write to us on WhatsApp with the code or the shaft dimensions and we will quote it promptly. We can also advise you on mounting and lubrication so that the unit works under the right conditions.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.