LINK-BELT WG219EL insert bearing

LINK-BELT WG219EL is a reference of insert bearing, within Bearings. Request a quote for WG219EL via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The LINK-BELT WG EL series insert bearing is a ball bearing with an extended inner ring, designed to be mounted in split plummer block housings and take-up frames. It is used in power transmission equipment where a compact unit with easy mounting and good radial load capacity is required. MR Accesorios Industriales supplies this line to plants and workshops throughout Argentina.

The WG EL series designation reads as follows: the letters WG identify the insert type with extended inner ring and set screw locking; the EL suffix corresponds to the version with reinforced sealing. The numbers in between indicate the bore diameter: for example, WG210EL, WG212EL and WG214EL cover increasing sizes within the 200 series. Each part number combines these three parts and defines the exact piece that goes into the housing.

These insert bearings are used in belt conveyors, bucket elevators, mixers, mills, packaging lines and process equipment in food, chemical, cement and aggregate plants. In Argentina they are common in production lines that need fast replacements without disassembling the entire housing. The 200 series is the most widespread for medium-diameter shafts, and the range of sizes covers different positions within the same machine.

To select the correct insert, take into account the shaft diameter, the housing type and the operating conditions. The EL sealing protects against dust and moisture, so it is recommended for dirty environments or frequent washdowns. Check that the inner ring is properly locked onto the shaft with the set screws and that lubrication is suitable for the operating temperature. Correct housing alignment extends bearing life and prevents unnecessary axial loads.

The 200 series insert bearings are interchangeable between different brands that use the same basic nomenclature, although the sealing, locking or internal clearance may vary. When requesting a quote, it is best to provide the complete insert part number and, if possible, the shaft and housing dimensions. MR Accesorios Industriales will indicate the compatible alternative.

If you need a LINK-BELT WG EL insert bearing, write to us on WhatsApp with the part number or model you are looking for. We will quote it promptly and advise you so that the replacement is the correct one.