Insert bearing LINK-BELT UG2M85NL

LINK-BELT UG2M85NL is a insert bearing reference, within Bearings. Request a quote for UG2M85NL via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The LINK-BELT UG200 series insert bearing is a single-row ball bearing with an extended inner ring, designed to be mounted in split or pillow block housings and to withstand moderate radial and axial loads in equipment with rotating shafts. It is used in conveyors, agitators, pumps, fans and process machinery where ease of mounting and sealing against contaminants are key. MR Accesorios Industriales supplies this line as an official brand in Buenos Aires, Argentina.

The UG200 series designation is read in blocks: UG identifies the family of insert bearings with extended inner ring and set screw locking; 200 corresponds to the metric diameter series. The number following the M indicates the shaft diameter: for example, UG2M17NL, UG2M20NL, UG2M25NL, UG2M30NL, UG2M35NL, UG2M40NL, UG2M45NL and UG2M50NL cover shafts from 17 to 50 mm. The NL suffix indicates the sealing type, and additional symbols mark locking variants or design features. With the complete part number we can quote the exact reference.

These inserts are selected in food and beverage plants, material handling, water treatment, cement plants and chemical plants. In Argentina they are found in belt and chain conveyors, bucket elevators, mixers, dryers, centrifugal pumps and industrial fans. Their extended inner ring allows them to be mounted in split housings, which simplifies replacement in equipment where access is limited and the shaft needs to be put into service without disassembling the entire assembly.

To select the insert, check the shaft diameter, the type of load and the environmental conditions. The NL seal protects against dust and moisture; in environments with frequent washdowns or fine particles, it is advisable to check the condition of the lips and the lubrication. Mounting is done with a clean, burr-free shaft, tightening the set screws on the inner ring with the appropriate wrench. Correct alignment between housings prevents additional loads and extends bearing life. Lubrication must be the one specified by the equipment manufacturer and renewed according to the maintenance plan.

Metric series insert bearings such as the UG200 are interchangeable between brands that respect the same shaft dimensions, width and locking. When comparing with other designations, always check the shaft diameter, the sealing type and the locking system, because small differences in the outer ring or in the position of the set screws can prevent mounting. If you need to replace an existing insert, send us the part number engraved on the bearing or the shaft and housing dimensions, and we will indicate the compatible alternative.

MR Accesorios Industriales supplies the LINK-BELT line as an official brand in Buenos Aires, Argentina, with more than 80 years of experience in bearings and power transmission. If you are looking for a UG200 insert for your equipment, write to us on WhatsApp with the part number or model you need: we will quote it and provide technical support so you can choose correctly. We can also advise you on housings, seals and complementary lubricants for your application.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.